Sensors/Others

A simple flex sensor 2.2" in length. As the sensor is flexed, the resistance across the sensor increases. Patented technology by Spectra Symbol - t...

This pressure sensor from Freescale is a great low-cost sensing solution for measuring barometric pressure. At 1.5 hPa resolution, it's not as pre...

This basic piezo sensor is often used for flex, touch, vibration and shock measurements. A small AC and large voltage (up to +/-90V) is created w...

Sharp's GP2Y1010AU0F is an optical air quality sensor, designed to sense dust particles. An infrared emitting diode and a phototransistor are di...

This basic piezo sensor is often used for flex, touch, vibration and shock measurements. A small AC and large voltage (up to +/-90V) is created w...

The Minisense 100 is a low-cost cantilever-type vibration sensor loaded by a mass to offer high sensitivity at low frequencies. Useful for detect...

This is your simple three conductor sensor cable with electrode pad leads. These cables are 24" long and feature a 3.5mm audio jack connector on o...

This is a passive electrode for a SHIELD-EKG-EMG shield which allows Arduino like boards to capture Electrocardiography Electromyography signals. ...

Now mounted on a breakout board, the MPL115A1 is a digital barometric pressure sensor that uses MEMs technology to give accurate pressure measu...

This is the T5403 breakout board, a fully calibrated barometric pressure sensor with an I 2 C interface. The T5403 sensor measures the absolute pre...

BMP085 is barometric pressure digital sensor which measures pressure in range 300..1100hPa (+9000m .. -500m above sea level) BMP085 is with I2C i...

This is the MS5803-14BA Pressure Sensor Breakout, a high resolution pressure sensor with both an I 2 C and SPI interface. This MEMS pressure sensor...

The H2OhNo! is a water sensor alarm kit that you build yourself. When water is detected across the sense pins an alarm goes off and an LED starts b...

This is the MyoWare Proto Shield, a simple proto-board for your MyoWare Muscle Sensor. With this shield you will be able to use the area provided t...

PROFESSIONAL STICKY ECG GEL ELECTRODES

The MyoWare LED Shield is designed to pair with the MyoWare Muscle Sensor. The blue 10-segment bar graph shows the magnitude of the measured signa...

Fingerprint scanners have been easily available at a consumer level for a number of years now, so it is only logical that they would continue to g...

Light sensor with built in pulse driver circuit and sync detector. Useful as a wide-angle proximity detector or for non-contact bump sensing. The...

This Art Controller Relay Kit from Evil Mad Scientist is a stand-alone relay board with an on-board ATtiny2313 microcontroller which governs timing...

Using our muscles to control things is the way that most of us are accustomed to doing it. We push buttons, pull levers, move joysticks…...