Adafruit

We have all sorts of LED strips for a wide range of needs. Chonky strips? We got those! Strips with alligator clips that are easy-peasy to MakeCode...

Just about all electronics use a UART serial port with RX and TX pins for debugging, bootloading, programming, serial output, etc. But it's rare fo...

We are very excited to carry a new book by Adafruit Learning System author and maker Kathy Ceceri! Robots are everywhere! They vacuum our houses, w...

Pipe audio in or out of your project with this very handy panel mount audio jack. It's a mono jack with a disconnect pin so you'll get a ground sle...

This 9-pin cable is just about 100mm / 4" long and fitted with JST-SH female connectors on both ends. Compared with chunkier JST-PH these are 1mm p...

We are very excited to carry a new book by Adafruit Learning System author and maker Kathy Ceceri! Robots are everywhere! They vacuum our houses, w...

Meet the affordable 8 Channel LoRa gateway from TTN, The Things Indoor Gateway! Simple name for a straight-to-the point product. It's the new low c...

Ready Players 1 and 2? Double up on your MakeCode gaming with a Sync Cable! We got this Micro B USB to Micro B USB cable specially made to connect ...

Looking for a way to keep your Raspberry Pi 4 running cool and also look cool? We've got a two-birds-one-stone solution for you. This enclosure kit...

Looking for a way to keep your Raspberry Pi 4 running cool and also look cool? We've got a two-birds-one-stone solution for you. This enclosure kit...

This cable is a little over 100mm / 4" long and fitted with JST-PH 3-pin connectors on either end. We dig the solid and compact nature of these con...

If you're a DIY enthusiast who likes to micro-manage your project's connections, here is a 10-pack of some micro 1mm pitch connectors that are JST ...

This tiny little servo can rotate approximately 180 degrees (90 in each direction), and works just like the standard kinds you're used to but small...

Who else could pack a 600 MHz microcontroller into such a Teensy little board? The Teensy 4.0 features an ARM Cortex-M7 processor at 600 MHz, with ...

You love NeoPixels, and you love silicone diffusion? Peep this Flexible Silicone Neon-like Skinny NeoPixel LED Strip! OK it's a bit of a mouthful, ...

This is hot! Literally! Apply 5-12VDC and the stainless steel fibers in this heating fabric will warm up, creating a little heating pad. On one han...

When working with unusual non-header-friendly surfaces, these handy cables will be your best friends! No longer will you have long, cumbersome stra...

ΩMG! You're not going to be able to resist these handy resistor packs! Well, axially, they do all of the resisting for you!This is a 25 Pack of 1.0...

ΩMG! You're not going to be able to resist these handy resistor packs! Well, axially, they do all of the resisting for you!This is a 25 Pack of 100...

The ESP-32-based M5Stick-C is a wee, super portable, open-source IoT development board, like a fun-sized version of the M5Stack. Jam-packed with a ...

Here's a hand-held-size rechargeable battery pack for your Raspberry Pi (or Metro, or anything else that uses 5V!). This pack is intended for provi...

If you're building a Raspberry Pi project and need to send data back-and-forth, the WiFi module built into newer Pi's should be fine for most cases...

This is a screen for advanced hackers who like the look of the TFT screen we've put into the PyPortal, PiTFT Plus, and TFT breakout. This display h...

Slip slidin' away Slip slidin' away You know the nearer your resistance The more you're slip slidin' awayIf you're tired of the regular-old-twisty ...