Prodotti

The Gameduino 3X Dazzler is an Adafruit Feather M4-compatible underwing that outputs HD picture and sound to any HDMI display or TV.The Dazzler is ...

Garmin's LIDAR-Lite LED V4 is the latest, ideal high-performance (but compact) optical distant measurement sensor solution for robotics, Internet o...

You've heard about the sensors in the news, when used in self-driving cars, and now you can have your own! Garmin's LIDAR-Lite V3 is the ideal high...

The LIDAR-Lite v4 LED sensor is the next step in the LIDAR-Lite line. A small, lightweight, low-power optical ranging sensor. It\'s the first to in...

The LIDAR-Lite v4 Qwiic from GARMIN is a high-performance, wireless optical distance measurement sensor that doesn\'t require any soldering to get ...

 Simple breakout board for the MQ - 3, MQ - 4, MQ - 6 and MQ - 7 gas sensors.  All you need is VCC at 5V, GND, and a resistor to an ADC, that is it...

The ZMOD4450 Gas Sensor Module is designed for detecting gases associated with food ripening or rotting, and is targeted for use in refrigeration a...

These little chips are like miniature SSD drives for your electronics. When you don't need something with as much storage as a micro SD card, but a...

This is a 15cm 18Pin FPC flat flex Ribbon cable specially designed for working with GDI. The cable is well durable and hard to be damaged even whe...

This is a 20cm 18Pin FPC flat flex Ribbon cable specially designed for working with GDI. The cable is well durable and hard to be damaged even whe...

This is a 30cm 18Pin FPC flat flex Ribbon cable specially designed for working with GDI. The cable is well durable and hard to be damaged even whe...

This is a 5cm 18Pin FPC flat flex Ribbon cable specially designed for working with GDI. The cable is well durable and hard to be damaged even when...

This is a 10cm 18Pin FPC flat flex Ribbon cable specially designed for working with GDI. The cable is well durable and hard to be damaged even whe...

FEATURES Operating voltage 6VDC Idle current 0.012A Stall current 0.12A

This motor is much like the GM2 gear motor but runs at nearly twice the speed. Mechanical Features 143:1 gear reduction ratio 7mm output shaft wi...

You only need one motor per side on a tracked vehicle, but you'll need at least one idler wheel to stretch the tread 270014 e 270015 between two...

Mainly used in air conditioner louver, small cooling and heating fan etc. Stable and all technic parameters are qualified for national electronic s...

The first step in a robotics project is to get a motor spinning. Once you've done that, you quickly learn that not all motors go the same speed, ev...

  81:1, 454RPM, 20mA (220mA stall) at 6V gives 3.17in*oz torque. Not bad, eh? And only available from Solarbotics ! These little gear motors measur...

VDR interference suppression on the collector Direction of rotation depending on polarity Can be mounted in any position Maximum radi...

SIX POLES MAGNET:THREE PULSES FOR MOTOR TURN HALL-EFFECT SWITCHES These Hall-effect switches are highly tempertature stable and stress-resistant s...

Planetary gear-motor. Motor interference suppression by VDR. Outgoing shaft two ball bearings supported Technical specifications Nominal volta...