Cataloghi

When you need to switch a lot of power, N-channel MOSFETs are best for the job. These FETs can switch over 60A and 30V and are TO-220 packages so t...

Heat shrink is the duct tape of electronics, it keeps your stuff all safe and kept together. Especially when wiring and soldering, use heat shrink ...

Handy for making wire harnesses or jumpering between headers on PCB's. These premium jumper wires approximately 6" (150mm) long and come in a 'stri...

Red and black tinned wires with a 2-pin JST PH connector on the end. 4" / 100mm long. Matches up nicely with our Lipoly chargers!We have the socket...

This sensor can detect flexing or bending in one direction. They were popularized by being used in the Nintendo PowerGlove as a gaming interface.Th...

Tiny little servo can rotate approximately 180 degrees (90 in each direction) and works just like the standard kinds you're used to but smaller. Yo...

Strangely enough, that's the technical term for this desoldering vacuum tool. Useful in cleaning up mistakes, every electrical engineer has one of ...

This is a 9V battery pack with on/off switch and a pre-attached 5.5mm/2.1mm center-positive barrel plug. Use this to battery-power your Arduino (or...

This is a cute, half-size breadboard with 400 tie points, good for small projects. It's 3.25" x 2.2" / 8.3cm x 5.5cm with a standard double-strip i...

Electronics and water don't usually mix - which is why liquid level sensing projects can be a little challenging. You can DIY a sensor but keeping ...

With its freely available development resources, ESP32-S3-BOX-3 is the ultimate choice for prototyping new projects or building complex AIoT system...

This is an ancillary kit for "Paper Circuits" -- a new book by Andrew Miller from Makerspaces.com!A paper circuit is a low-voltage electronic circu...

The Adafruit TS3USB30 1 to 2 USB Switch is a nifty breakout board for the TI TS3USB30 that will let you connect one of two USB devices to a single ...

The Adafruit MCP3421 18-Bit ADC is a simple, inexpensive, and easy to use 18-bit, 240 SPS, single-channel ADC with an I2C interface that can run up...

Hobby-level microcontrollers are finally getting big and powerful enough to start handling camera modules that historically would have required a f...

Hobby-level microcontrollers are finally getting big and powerful enough to start handling camera modules that historically would have required a f...

Hobby-level microcontrollers are finally getting big and powerful enough to start handling camera modules that historically would have required a f...

Many microcontrollers have ADCs these days, for reading analog/resistive sensors like potentiometers, thermistors, LDR light sensors, etc. but some...

With most of our dev boards, sensors and feathers now sporting plug-and-play stemma QT ports it can be very fast to put together projects with half...

The Adafruit Feather series gives you lots of options for a small, portable, rechargeable microcontroller board. By picking a feather and stacking ...

Tip-Ring-Ring-Sleeve style audio cables are often used for situations where you want stereo audio and then an extra contact for a microphone input....

Ding dong! Hear that? It's the PiCowbell ringing, letting you know that the new Adafruit PiCowbell DVI Output for Pico is in stock and ready to dis...

You're probably really used to microcontroller boards with USB, but what about a dev board with two? Two is more than one, so that makes it twice a...

This breakout board is a "three in one" product: The ATtiny1616 is part of the 'next gen' of AVR microcontrollers, and now we have a cute developme...