Cataloghi

These wireless transmitters work with our 315MHz receivers. They can easily fit into a breadboard and work well with microcontrollers to create a v...

These wireless transmitters work with our 434MHz receivers. They can easily fit into a breadboard and work well with microcontrollers to create a v...

These wireless receivers work with our 315MHz transmitters. They can easily fit into a breadboard and work well with microcontrollers to create a v...

These wireless receivers work with our 434MHz transmitters. They can easily fit into a breadboard and work well with microcontrollers to create a v...

This is an inner thread (outer nut) adapter that will connect to any of our wireless boards or interface cables and allow you to use an antenna/cab...

This is an adapter that converts an RP-SMA board to an SMA antenna. The adapter will connect to any of our 2.4GHz wireless boards ([Bluetooth](http...

This is a 4\" connector cable that interfaces U.FL RF connectors to regular SMA connectors. This cable is commonly used to connect larger GPS anten...

Itty-bitty U.FL SMD connector. Great for tight PCB layouts that require antenna connections. **Documents:** * [Datasheet](http://cdn.sparkfun.com...

900/1800 MHz Duck Antenna 2dBi with regular RP-SMA RF connector. Perfect for use with the XBee 900MHz units. 50 ohm impedance. 105mm long. Be sure...

Commonly used to attach WiFi, Bluetooth, or nRFxxx based devices to a 2.4GHz antenna. **Features:** * 4\" Length **Documents:** * [Datasheet](h...

PCB edge mount - SMA RF connector. Perfect for prototyping with the GPS and Cellular devices that require an antenna connection. These connectors h...

PCB edge mount Reverse Polarized - SMA RF connector. Perfect for prototyping with our RF ICs. This is a standard edge connector. The thickness betw...

Need range? 2.4GHz Large Duck Antenna 5dBi with Reverse Polarized - SMA RF connector. Perfect for prototyping with our RF ICs. 50 ohm impedance. ...

2.4GHz Duck Antenna 2.2dBi with Reverse Polarized - SMA RF connector. Perfect for prototyping with our RF ICs. 50 ohm impedance. 4\" long. Not sur...

2.4GHz ceramic chip antennas. Very small antennas that work nicely with the Nordic ICs. Don\'t expect these little guys to perform as well as their...

Have you ever had problems trying to daisy chain Qwiic-enabled boards with only ONE Qwiic connector? Or maybe you need a Qwiic-enabled device that ...

Based on a new generation ARM Cortex M7, this version of the Qwiic Tsunami Super WAV Trigger extends polyphony to **_25 mono or 13 stereo_** simult...

We have stock of the Tsunami Super WAV Trigger - 25 Voice (Qwiic) as an alternative! Notice: Supply chain constraints have made the ATSAMS70N20 ...

The 6-Channel Temperature Monitor can measure temperatures from as low as −240°C up to +850°C (real-world limits greatly depend on the sensors bein...

The SparkFun Continuous Rotation (CR) Servo Trigger is a small robotics board that simplifies the control of hobby RC servo motors. When an externa...

Make some noise with your next project! The MP3 Trigger board is built to make MP3 sound integration easier than ever. The board has 18 external tr...

The SparkFun Servo Trigger is a small robotics board that simplifies the control of hobby RC servo motors. When an external switch or logic signal ...

The SparkFun Logomatic v2 takes everything we learned with logging analog or serial data from your projects over the years and boils it down to an ...

This board allows you to interface with your car\'s OBD-II bus. It provides you a serial interface using the ELM327 command set and supports all ma...