2377 - 10:1 Micro Metal Gearmotor MP with Extended Motor Shaft
Tutti i prezzi sono IVA inclusa
This gearmotor is a miniature (0.94" x 0.39" x 0.47") brushed DC motor with 9.96:1 metal gearbox, similar to Sanyo’s popular 12 mm gearmotors. These units have a 0.365"-long, 3 mm-diameter D-shaped output shaft. This version also has a 4.5 x 1 mm extended motor shaft.
Key specs at 6 V: 2200 RPM and 40 mA free-run, 3 oz-in (0.2 kg-cm) and 0.7 A stall.
These tiny brushed DC gearmotors are intended for use at 6 V, though in general, these kinds of motors can run at voltages above and below this nominal voltage, so they should comfortably operate in the 3 – 9 V range (rotation can start at voltages as low as 0.5 V). Lower voltages might not be practical, and higher voltages could start negatively affecting the life of the motor. The micro metal gearmotors are available in a wide range of gear ratios—from 5:1 up to 1000:1—and offer a choice between three different motors: high-power (HP), medium-power (MP), and standard. With the exception of the 1000:1 gear ratio versions, all of the micro metal gearmotors have the same physical dimensions, so one version can be easily swapped for another if your design requirements change. This dynamically-sortable table can help you find the gearmotor that offers the best blend of speed, torque, and current-draw for your particular application. A more basic comparison table is available below.
Some versions of the gearmotors are sold with an additional 1mm-diameter output shaft that protrudes from the rear of the motor. This 4.5mm-long rear shaft rotates at the same speed as the input to the gearbox and offers a way to add an encoder, such as our magnetic encoder for micro metal gearmotors, to provide motor speed or position feedback.
The gearbox has a long (0.365" or 9.27 mm), 3 mm-diameter D-shaped metal output shaft, and the brass faceplate has two mounting holes threaded for M1.6 screws (1.6 mm diameter, 0.35 mm thread pitch). The gearmotor weighs approximately 0.35 oz (10 g). Versions with the extended motor shaft have a 1mm diameter round shaft that protrudes 4.5 mm from the rear of the motor, between the two motor terminals; this is not pictured in the above dimension diagram. In terms of size, these gearmotors are very similar to Sanyo’s popular 12 mm NA4S DC gearmotors, and gearmotors with this form factor are often referred to as N20 motors.
Dimensions
| Size: | 24 x 10 x 12 mm |
|---|---|
| Weight: | 0.34 oz |
| Shaft diameter: | 3 mm |
General specifications
| Gear ratio: | 9.96:1 |
|---|---|
| Free-run speed @ 6V: | 2200 rpm |
| Free-run current @ 6V: | 40 mA |
| Stall current @ 6V: | 700 mA |
| Stall torque @ 6V: | 3 oz·in |
| Extended motor shaft?: | Y |