MAGENTO IMPORT

This is a 35mm round momentary push button similar to the ones you find on arcade games. Simple screw in design. Perfect for mashing. Features: ...

  Integrating Ethernet support into your project is a great way to relay data through a local area network and even bounce information out to the...

  The Arduino Funnel I/O (Fio) is a board designed by Shigeru Kobayashi, based on the original design from LilyPad.  Funnel is a toolkit to sketch...

Here at SparkFun, we refuse to leave 'good enough' alone. That's why we're adding to our line-up of Arduino-compatible microcontrollers once more! ...

This is a three axis accelerometer for the LilyPad system. Based on the ADXL335 accelerometer from Analog Devices, the LilyPad Accelerometer can de...

  This is a simple LED-illuminated tactile button with a green cap. It's just like a basic tactile button, but it lights up red! So now you can g...

USB On-The-Go is a really useful USB specification! It allows some small devices that would usually be unable to act as a host to have limited host...

  This is a crimp pin for the ZH-6 JST connector, which can be used to interface with the GP2Y1010AU0F Optical Dust Sensor. These are sold as indiv...

  This is a simple 3 wire cable. Great for jumping from board to board or just about anything else. There is a 3-pin JST RE connector on both end...

These plastic Flexible Coolant Pipes have been primarily used to spray refrigeration or washing fluid for machine tools but, thanks to their articu...

The Raspberry Pi Model B+ is THE new favorite of development platforms, so the last thing that you’d want is for something bad to happen to it. Why...

USB Type 'A' Female SMD connector. For use with any PCB that will be used with a Type A to Type A USB cable. Designed to mount to the UBW32. Doc...

You've got the wrong USB cable. It doesn't matter which one you have, it's the wrong one. But what if you could have the right one? What if you cou...

This is the knob that connects to the linear slide potentiometer.  Knob has a nice friction fit onto slide.Documents: Datasheet

Once you've hacked everything, why not go out in the garage and hack your car? This cable allows you to access the pins on your car's OBDII connect...

This is the Big Red Box! These beefy, bright red, flanged, plastic enclosures will give your widget the protection (and attention) it deserves. You...

We designed this board to give the user a very discrete button without any sharp edges. Button closes when you push it and opens when you release ...

The ADXL337 is a small, thin, low power, complete 3-axis accelerometer with signal conditioned analog voltage outputs that measures acceleration wi...

  These 10 segment bar graph LEDs have many uses. With a compact footprint, simple hookup, they are easy for prototyping or finished products. Esse...

  This is a 6-pin 1.5mm pitch connector which mates directly with the connector on the Sharp GP2Y1010AU0F optical dust sensor. This is a ZH series ...

Rubber feet raise your PCB or project up off your desk. This helps prevent short circuiting from bits of scrap wire floating about or setting a p...

This is a board designed for opto-isolation. This board is helpful for connecting digital systems (like a 5V microcontroller) to a high-voltage or ...

This is the Magnetic Door Switch Set, a small reed switch assembly specifically designed to alert you when doors, drawers, or any other aperture op...

This is a USB to TTL Serial Cable which allows for a simple way to connect TTL interface devices to USB. The I/O pins of this cable are configured ...