Motor & Servo Controllers/Motor Controllers

  Designed to work with our EMG49 gear motors, the MD49 will drive two motors. Controllled by Serial Interface at 9600 or 38400 baud. Two modes of ...

This breakout board makes it easy to use Toshiba’s TB9051FTG brushed DC motor driver. It has a wide operating voltage range of 4.5 V to 28 V and ca...

This powerful motor controller makes basic control of a brushed DC motor easy, with quick configuration over USB using our free software. It suppo...

This discrete MOSFET H-bridge motor driver enables bidirectional control of one high-power DC brushed motor. The small 1.3″ × 0.8″ board supports a...

This breakout board makes it easy to use Toshiba’s TB67H420FTG brushed DC motor driver, which can operate in either dual-channel mode for independe...

This powerful motor controller makes basic control of a brushed DC motor easy, with quick configuration over USB using our free software. It suppo...

This discrete MOSFET H-bridge motor driver enables bidirectional control of one high-power DC brushed motor. The small 1.3″ × 0.8″ board supports a...

  This lower-power, smaller, and lower-cost version of the TReX is the ultimate general-purpose motor controller for small motors: it has a wide op...

This shield makes it easy to control two high-power DC motors with your Arduino or Arduino-compatible board. Its twin discrete MOSFET H-bridges sup...

This powerful motor controller makes basic control of a brushed DC motor easy, with quick configuration over USB using our free software. It suppo...

Ready to add some good vibes to your project? Look no further than the SparkFun Haptic Motor Driver. This board breaks out Texas Instruments' ...

This powerful motor controller makes closed-loop speed or position (but not both!) control of a brushed DC motor easy, with quick configuration ove...

  The 991.009 is a small module you can directly mount on a 40x40mm 5VDC Fan. Just provide a 5VDC 100-250mA power source and an analog output for t...

This powerful motor controller makes basic control of a brushed DC motor easy, with quick configuration over USB using our free software. It suppo...

  The TReX blends RC, analog, and serial inputs for a powerful motor control solution capable of delivering a continuous 13 A per motor. The TReX w...

This powerful motor controller makes closed-loop speed or position (but not both!) control of a brushed DC motor easy, with quick configuration ove...

This shield makes it easy to control two high-power DC motors with your Arduino or Arduino-compatible board. Its twin discrete MOSFET H-bridges sup...

  The jrk 21v3 motor controller is a highly configurable brushed DC motor controller that supports four interface modes: USB, logic-level serial, a...

  The TReX blends RC, analog, and serial inputs for a powerful motor control solution capable of delivering a continuous 13 A per motor. The TReX w...

  This lower-power, smaller, and lower-cost version of the TReX is the ultimate general-purpose motor controller for small motors: it has a wide op...