Motori

The Big Easy Driver, designed by Brian Schmalz, is a stepper motor driver board for bi-polar stepper motors up to a max 2A/phase. It is based on th...

Motoriduttore epicicloidale  dotato di soppressore di disturbi VDR. Albero di uscita supportato da 2 cuscinetti a sfere  Caratteristiche Tensione ...

Planetary gear-motor. Motor interference suppression by VDR. Outgoing shaft two ball bearings supported Technical specifications Nominal volta...

The HS-755MG is a quarter scale Metal Gear Servo for larger R/C applications. Featuring Dual Ball Bearings with a water and dust tight case, the HS...

This shield makes it easy to control two brushed DC motors with your Arduino or Arduino-compatible board. Its dual MC33926 motor drivers operate f...

This breakout board is the ultimate companion for the VLSI VS1053B DSP codec chip. The VS1053 can decode a wide variety of audio formats such as MP...

These steppers have a threaded shaft, which allows them to be used as a linear actuator. As the motor runs, it moves along the shaft at a specific ...

This is a clever little breakout board for both the RGB and R/G illuminated rotary encoders. On one side, it breaks out all of the RGB pins to stan...

  The jrk 21v3 motor controller is a highly configurable brushed DC motor controller that supports four interface modes: USB, logic-level serial, a...

VDR interference suppression on the collector Direction of rotation depending on polarity Can be mounted in any position Maximum radi...

BB-VNH3SP30 is full bridge driver with up to 30A and 36V working voltage. It is good to drive Gear Robot motors with reversal function. STATUS LEDs...

This small shield is an easy, economical way to control two small brushed DC motors with an Arduino or Arduino-compatible board. Its integrated DR...

  This gearmotor is a miniature (0.94" x 0.39" x 0.47"), high-quality, low-current motor with 100:1 metal gearbox, similar to Sanyo’s popular 12 mm...

This high-speed bipolar stepper with a rear shaft has a 1.8° step angle and 11 kg·cm of torque at low speeds.This NEMA-23 motor generates 12.6 kg-c...

The EasyDriver is a simple to use stepper motor driver, compatible with anything that can output a digital 0 to 5V pulse (or 0 to 3.3V pulse if you...

This coated steel mounting bracket provides a simple means of attaching a NEMA-23 sized stepper motor to a flat surface. It has two sets of mountin...

  The HS-785HB sail winch servo with its large drum wheel has 3 1/2 revolutions of travel for hauling in even the largest of sails. With its dual b...

Hitec’s HS-45HB offers the economy and durability of our other famous micro servos, but now with a ball bearing supported output shaft and Karbon...

** DESCRIPTION  AX-12A is a new version of the AX-12+ with the same performance but more adva...

VDR interference suppression on the collector Direction of rotation depending on polarity Can be mounted in any position Maximum radi...

This compact, economical optical quadrature encoder can be attached to the 4mm rear shaft of a motor. It has 300 counts (full quadrature cycles) pe...

    Since its introduction, the HS-55 has set the standard for affordable performance, offering precision components that have been engineered to p...