Automazione

Controlled over Ethernet using simple TCP/IP commands.Relays - 4Digital Switching I/O channels - 8Analogue Inputs - 4 x 3.3v 12 bit or 10 bit for b...

Powered and Controlled from the USB bus.Relays - 2 with integrated snubbing of the normally open terminalsPower - Powered from standard USB bus Con...

OPEN SOURCE HARDWARE EMBEDDED MIPS LINUX SINGLE BOARD COMPUTER WITH RT5350F SOC 2.4GHZ WIFI 801.11N 150MB X2 100MB ETHERNET PORTS RELAYS, BUTTON F...

Controlled over WIFI using preprogrammed command sets or html page. The ESP32LR88 is a WIFI connected relay module using the popular ESP32. It prov...

The ETH8020-B is a drop in update of the ETH8020 with additional upgrades. The ETH8020 provides 20 volt free contact relay outputs with a current r...

ESP8266 is very highly integrated SOC which includes Xtensa LX106 core processor, RAM, RF front end and allow WIFI TCP-IP stack to be implemented o...

  The SCR02 is a sensor controlled relay module capable of autonomous operation. The SRC02 may be connected to most of our ultrasonic rangers or to...

The MIDI-RLY8 provides 8 relay outputs that respond to midi note or control change messages, these can be either mechanical or solid state relays. ...

dS3484 case. Includes mounting holes for fixing to a wall or back panel. This precision snap together case includes screws for mounting the dS3484 ...

Thermocouples are widely used to measure extreme temperatures impossible to measure with other types of sensors. J, K, E and T thermocouples are di...

  Product Features Measures the frequency of an analog or digital signal Measures zero-centered signals with a minimum amplitude of 110mV ...

Product Description The PhidgetAnalog 4-Output Produces a voltage over -10V to +10V. This voltage will be asserted up to +-20mA. An error will b...

      The 4-20mASensors can be connected to and powered by the provided terminals on the 4-20mA Adapter board. The 1132 will measure the current ...

The PhidgetInterfaceKit 0/0/4 allows you to control high power devices such as incandescent light bulbs, fans, and pumps by electronically switchin...

Controlled over Ethernet using simple TCP/IP commands.Relays - 2Power - 12V DC adaptor, supplied separatelyConfiguration & Test interface - HTT...

Powered and Controlled from the USB bus.The relays used on this board are premium ultra low power 50mW coil types, this means the boards current ...

Right out of the box -Simple configuration and setup from your web browser.Control it from a web page, or select tcp/ip control with an option of A...

The WIFI002 provides 2 volt free contact relay outputs with a current rating of up to 16Amp each, the module is powered from a 12vdc supply which c...

  The 1133 measures sound across a very wide range, with a frequency range of 100Hz to 8kHz and pressure level from 50dB to 100dB.   Product Specif...

The Solid State Relay is used to switch up to 2.5 Amps at up to 40 Volts DC, or 28 Volts AC.   The SSR board is controlled by a digital output on ...

The 1121 provides an interface to non-Phidgets resistance sensors such as: Force-Sensing Resistors (FSR), light sensors, thermistors (heat sensors...

The 1106 reads 0 when no force is applied. As force increases on the circular button the value increases towards 1000.   It is intended as a user...

The PhidgetAdvancedServo 8-Motor allows you to control the position, velocity, and acceleration of up to 8 RC servo motors. It requires a 6-15VDC ...

The Phidget GPS provides the longitude and latitude of the board's position in signed decimal degree format. The position accuracy (best case) is 2...