schede & micro

The iceFUN module is powered from USB or an external 5v supply. There are on-board 3.3v and 1.2v regulators. All PIC and FPGA I/O pins are 3.3v...

Powered and Controlled from the USB bus.Relays - 6 with integrated snubbing of the normally open terminalsPower - Powered from standard USB bus Con...

Controlled over WIFI using preprogrammed command sets or html page. The ESP32LR20 is a WIFI connected relay module using the popular ESP32. It prov...

dS378 case. Includes mounting holes for fixing to a wall or back panel. This precision snap together case includes screws for mounting the dS378 mo...

Simple configuration and setup from your web browser.Control it from a web page, or select tcp/ip control with an option of ASCII, Binary or Modbus...

Powered and Controlled from the USB bus.Relays - 4 with integrated snubbing of the normally open terminalsPower - Powered from standard USB bus Con...

Provides arc suppression for switching inductive AC loads on relays. The snubber can be simply wired across the common and switched contact to stop...

iceWerx iCE40-HX8K FPGA 4 10-bit Analogue input channels via onboard PIC.63 FPGA I/O pins available (3.3 volt). iCE40 HX FPGA:7680 Logic cells128k ...

The BT004 provides four volt free contact relay outputs with a current rating of up to 16Amp each controlled over a HC06 Bluetooth serial port. The...

ETH8020 case. Includes mounting holes for fixing to a wall or back panel. This precision snap together case includes screws for mounting the ETH802...

dS2832 case. Includes mounting holes for fixing to a wall or back panel. This precision snap together case includes screws for mounting the dS2832 ...

Controlled over WIFI using preprogrammed command sets or html page.Relays - 8 x 1A 30v outputs using a 50mW ultra efficient relayInputs - 8 x optic...

The MIDI-RLY8 provides 8 relay outputs that respond to midi note or control change messages, these can be either mechanical or solid state relays. ...

WARNINGMains Voltages can be Lethal.If you are not confident with using these voltages, please use a qualified electrician to wire this up for you....

Expansion board for the dScript modules providing low voltage DC inputs (analogue or digital) and two extra relays, powered and controlled through ...

The MIDI-RLY8 provides 8 relay outputs that respond to midi note or control change messages, these can be either mechanical or solid state relays. ...

Controlled over Ethernet using simple TCP/IP commands or MQTT. Built with Inductive load switching in mind.Ideal for solenoids, relays, valves and ...

Simple configuration and setup from your web browser.Control it from a web page, or select tcp/ip control with an option of ASCII, Binary or Modbus...

Expansion board providing 230VAC opto inputs and two extra relays for the dScript modules, powered and controlled through the dS modules RS485 port...

Expansion K type Thermo-couple board and 2 extra relays for the dScript modules, powered and controlled through the dS modules RS485 port. Hardware...

The USB-RS485 is a complete, self powered, USB to RS485 interface working at any baud rate up to 250k baud. It features automatic bus turn-around -...

The MIDI-RLY8 provides 8 relay outputs that respond to midi note or control change messages, these can be either mechanical or solid state relays. ...

The BT004BLE provides four volt free contact relay outputs with a current rating of up to 16Amp each controlled over a HM10 Bluetooth serial port. ...

Controlled by modbus RTU over RS485, address, baud rate and parity set by dip switch. Relays - 8 VFC with snubbers on N/ODigital opto isolated inpu...