schede & micro

The 'must have' IC for TTL/CMOS projects finally has its own breakout board! This is the RS232 converter IC that is capable of running at 3V and co...

The USB-RS485 module provides an easy to use RS485 interface by means of a Virtual Com Port on the users system. There are no command structures,...

The SparkFun Load Cell Amplifier is a small breakout board for the HX711 IC that allows you to easily read load cells to measure weight. By connect...

The cable is easiest way ever to connect to your microcontroller/Raspberry Pi/WiFi router serial console port. Inside the big USB plug is a USB<...

This is the newest revision of our FTDI Basic. We now use a SMD 6-pin header on the bottom, which makes it smaller and more compact. Functionality ...

The Grove - Speaker is a module consist of power amplification and voice outputs. The loudness can be adjusted by the on-board potentiometer. ...

Breakout board for the microSD socket that is not much bigger than your fingernail. Compatible with the SPI interface found on any SD card, this ti...

This RC relay enables easy control of large, electrically isolated loads in radio control (RC) systems. The activation threshold and direction are...

The ETH002 provides two volt free contact relay outputs with a current rating of up to 16Amp each. The module is powered from a 12vdc supply which ...

Pimoroni's adjustable Pi Camera mount is a great accessory for Pi shutterbugs. Little screws attach the Pi Camera solidly and the design allows for...

The Sound Detector is a small and very easy to use audio sensing board with three different outputs. The Sound Detector not only provides an audio ...

Listen up! This set of two 2.8" x 1.2" speakers are the perfect addition to any audio project where you need 4 ohm impedance and 3W or less of powe...

  FEATURES: USB to serial cable three wires for Breadboard connection SERIAL output 3.3V voltage levels GND=BLUE, RX(INPUT)=GREEN, TX(OUTPUT)=RED ...

The ATtiny45 and 85 are a couple of really cool little MCUs but did you know you can program them in Arduino? That's right, now you can shrink your...

Here is a real time clock based on the DS3234 Real Time Clock IC. The DS3234 is a low-cost, extremely accurate SPI bus real-time clock with an inte...

ALUMINIUM-HEATSINK-20x20x6MM is a small (20x20x6)mm aluminium heatsink radiator specially made for A10/A20 BGA chips. During heavy computations lik...

Surface transducers give you the awesome power to turn almost any surface into a speaker. They’re essentially just a speaker except instead of a co...

This is a breakout board for the Texas Instruments TXB0104 module. The TXB0104 is a 4-bit bidirectional voltage-level translator with automatic dir...

This is a simple to use, USB to serial base unit for the Digi XBee line. This unit works with all XBee modules including the Series 1 and Series 2....

This incredibly small stereo amplifier is surprisingly powerful - able to deliver 2 x 3.7W channels into 3 ohm impedance speakers. Inside the minia...

The Photon is a tiny Wi-Fi development kit for creating connected projects and products for the Internet of Things. It's easy to use, it's powerful...

  Picaxe 08M2 is the smaller of Picaxe family. Has 6 I/Os. 3 I/Os can act as analog inputs. It can also play RTTL tunes using the "Tune Wizard" int...

Official microUSB Power Supply Unit for Raspberry Pi 3 Model B This Pi Foundation approved power supply unit (PSU) for the Pi 3, is available at RS...

This device is a programmer for AVR-based controllers, such as our Orangutan robot controllers and the 3pi robot. The programmer emulates an STK50...