schede & micro

The WIFI484 provides four volt free contact relay outputs with a current rating of up to 16Amp each, 8 digital I/O and 4 analogue inputs. The modul...

MOD-RGB is a completely open-source module suitable for controlling LED strips. The LED strips might be of the same color or different colors. The ...

This breakout board uses the LTC3588 Piezoelectric Energy Harvester from Linear Technologies. This board can be used not only for harvesting piezoe...

Listen to this good news - we now have an all in one digital audio amp breakout board that works incredibly well with the Raspberry Pi! If you're l...

Datasheet (245K) PDF

BOOTABLE MICRO SD CARD WITH DEBIAN IMAGE Please note: this SD card is suitable only for A10-OLinuXino-LIME

The DMX-USB-RX-D8 module is a fully compliant with the latest USITT DMX512-A standard, E1.11-2004. This small module, powered by a single 9V AC or ...

The MIDI-RLY08 provides 8 relay outputs that respond to midi note or control change messages, these can be either mechanical or solid state relays....

This is the SparkFun Rotary Switch Breakout, a very simple board designed to easily provide you access to each pin on our 10-position rotary switch...

Controlled over Ethernet using simple TCP/IP commands.Relays - 2Power - 12V DC adaptor, supplied separatelyConfiguration & Test interface - HTT...

  Powerful DSP-enanched picmicro @80MHz. Includes specific hardware for motor control. Features Architecture: 16bits CPU Speed: 40MIPS (80...

This is a very basic double sided prototyping board with standard  0.1" spacing through holes and four 3mm diameter mounting holes. There are 22x26...

Controlled over Ethernet using simple TCP/IP commands.Relays - 8Power - 12V DC adaptor, supplied separately.Configuration & Test interface - HT...

Powered and Controlled from the USB bus.The relays used on this board are premium ultra low power 50mW coil types, this means the boards current ...

Powered and Controlled from the USB bus.Relays - 2 with integrated snubbing of the normally open terminalsPower - Powered from standard USB bus Con...

The DMX-USB-RX-A8 module is a fully compliant with the latest USITT DMX512-A standard, E1.11-2004. This small module, powered by a single 18VAC sup...

USBtinyISP is a simple open-source USB AVR programmer and SPI interface. It is low cost, easy to make, works great with avrdude, has both 6 and 10 ...

Arch GPRS V2 is the new and improved version of the Arch GPRS development board from Seeed Studio. Like the original Arch GPRS, it is also an mbed...

The FTDI SmartBasic is a variation on our classic FTDI Basic board which allows you to connect a second device to the hardware serial port on an Ar...

FEATURES iMX233 ARM926J processor at 454Mhz 64 MB RAM SD-card connector for booting the Linux image 1 USB High Speed Host Three buttons UEXT conn...

Controlled over WIFI using preprogrammed command sets or html page. The ESP32LR88 is a WIFI connected relay module using the popular ESP32. It prov...

With some development boards, low power usage is an afterthought. Especially when price and usability are the main selling points. So what should y...

Teensy 4.0 is the latest Teensy, offering the fastest microcontroller and powerful peripherals in the Teensy 1.4 by 0.7 inch form factor. Feature...