Mounting Clevis for Glideforce Industrial-Duty Linear Actuators - Aluminum

This adapter was designed specifically for the Glideforce Industrial-Duty (ID) linear actuators and can be used to turn either end into a clevis-style bracket. It is machined out of a single piece of aluminum and has been tested to 1700 kgf [3800 lbs or 17,000 N] of static load, which is well above the highest static loads the ID actuators are rated for. The mounting pin has a 0.498″ (12.6 mm) diameter. This bracket is sold individually, and two brackets are required for each linear actuator.

This adapter works on either end of the Glideforce industrial-duty (ID) linear actuators.

A sleeve piece is included (visible set in the hole in the right picture above) to provide a better fit when using this on the back of the linear actuator, as shown below:

When using this on the extension rod of the linear actuator, which has a wider diameter, the sleeve should be removed:

See the bracket datasheet (332k pdf) for dimensions.

This product is Concentric part number LA-ID-CLEVIS.