SKU DFR0807
ESP32-C3-DevKitM-1 Development Board
Prezzo originale
€22,69
-
Prezzo originale
€22,69
Prezzo originale
€22,69
€22,69
-
€22,69
Prezzo attuale
€22,69
Tutti i prezzi sono IVA inclusa
Disponibilità:
Esaurito
Disponibilità:
Esaurito
Disponibilità:
Da Ordinare
ESP32-C3-DevKitM-1 is an entry-level development board based on ESP32-C3-MINI-1, a module named for its small size. This board integrates complete Wi-Fi and Bluetooth LE functions.
Most of the I/O pins on the ESP32-C3-MINI-1 module are broken out to the pin headers on both sides of this board for easy interfacing. Developers can either connect peripherals with jumper wires or mount ESP32-C3-DevKitM-1 on a breadboard.
Description of Components
| Key Component | Description |
| ESP32-C3-MINI-1 | ESP32-C3-MINI-1 is a general-purpose Wi-Fi and Bluetooth LE combo module that comes with a PCB antenna. At the core of this module is ESP32-C3FN4, a chip that has an embedded flash of 4 MB. Since flash is packaged in the ESP32-C3FN4 chip, rather than integrated into the module, ESP32-C3-MINI-1 has a smaller package size. |
| 5 V to 3.3 V LDO | Power regulator that converts a 5 V supply into a 3.3 V output. |
| 5 V Power On LED | Turns on when the USB power is connected to the board. |
| I/O Connector | All available GPIO pins (except for the SPI bus for flash) are broken out to the pin headers on the board. |
| Boot Button | Download button. Holding down Boot and then pressing Reset initiates Firmware Download mode for downloading firmware through the serial port. |
| Micro-USB Port | USB interface. Power supply for the board as well as the communication interface between a computer and the ESP32-C3FN4 chip. |
| Reset Button | Press this button to restart the system. |
| USB to UART Bridge | Single USB-to-UART bridge chip provides transfer rates up to 3 Mbps. |
| RGB LED | Addressable RGB LED (WS2812), driven by GPIO8. |
Pin Header
