Salta il contenuto

Lingua

SKU 808140

MiFare Classic (13.56MHz RFID/NFC) Card - 1KB

Esaurito
Prezzo originale €4,04 - Prezzo originale €4,04
Prezzo originale
€4,04
€4,04 - €4,04
Prezzo attuale €4,04

Tutti i prezzi sono IVA inclusa

Disponibilità:
Esaurito
Richiesta Sconto per Quantita' e Informazioni

This is a blank MiFare Classic card - often used for train/bus passes but also found in other systems where a proximity card is desired. The tag contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away.

These can be read by almost any 13.56MHz RFID/NFC reader but make sure it can handle MiFare cards as there are a few other encoding standards (like FeLica) They are tested and work great with both our PN532 NFC/RFID breakout board and Adafruit NFC/RFID Shield for Arduino!

These chips can be written to & store up to 1 KB of data in writable EEPROM divided into banks, and can handle over 100,000 re-writes. You can use our PN532 NFC/RFID breakout board or Adafruit NFC/RFID Shield for Arduino to read and write data to the EEPROM inside the tag. There is also a permanent 4-byte ID burned into the chip that you can use to identify one tag from another - the ID number cannot be changed.

S50 chip specification:

  • 1 KiloByte (8 KiloBit) non-volatile EEPROM storage
  • Built in encryption engine with 48-bit key
  • 4 Byte unique identifier burned into the chip
  • 13.56 MHz frequency

Tag specification:

  • 85.5mm x 54mm x 1mm /3.36" x 2.1" x 0.03"
  •  
  • 6.3 grams / 0.2 oz
  • Works about 4" away from reader

Downloads:

NXP S50 datasheet