MAGENTO IMPORT

  Rotary encoders are used similarly to potentiometers. They're different from potentiometers in that an encoder has full rotation without limits. ...

  This hybrid bipolar stepping motor has a 1.8° step angle (200 steps/revolution). Each phase draws 280 mA at 7.4 V, allowing for a holding torque ...

It's your basic black action button! This is a very useful, small, panel-mount momentary switch. It is a SPST N.O. with 1/4" threading.  This butto...

  Simple shrouded 10-pin connector. Good for preventing cable connection mishaps. Use for programming, data, power, or any other kind of connection...

The Arduino Ethernet Shield 2 connects your Arduino to the internet in mere minutes. Just plug this module onto your Arduino Board, connect it to y...

 Simple breakout board for the MQ - 3, MQ - 4, MQ - 6 and MQ - 7 gas sensors.  All you need is VCC at 5V, GND, and a resistor to an ADC, that is it...

High quality potentiometer. L = 15mm

Cavetto USB versione 2.0

These are 150mm long jumpers with male connectors on both ends. Use these to jumper from any female header on any board, to any other female heade...

Connect this to that with a set-screw coupler. These couplers are made of machined aluminum and have a spiral cut that makes them slightly flexible...

This is similar to other 16x2 character LCDs that you’ve seen before but with one vibrant difference: The backlight is actually an RGB LED. This me...

This is a rechargeable Li-Po high discharge current battery with JST connector ready to plug to: OLIMEXINO-328, OLIMEXINO-STM32, PIC32-PINGUINO, PI...

  This is a simple 6 wire cable. Great for jumping from board to board or just about anything else. They have bare wires on one end and a 6-pin JS...

I2C Hub Grove is an extension Grove module for connecting multiply I2C devices to Grove Base Shield. It can use with the Universal 4 Pin to ...

  This is a simple 4 wire cable. Great for jumping from board to board or just about anything else. They have bare wires on one end and a 4-pin JS...

Technical Specifications: Nominal Coil Voltage 12V DC Max Allowable Current 1A max (120Vac / 30Vcc) ...

This temperature & humidity sensor provides a pre-calibrated digital output. A unique capacitive sensor element measures relative humidity and ...

This is a perfect choice if you are in need of a heavy duty push button! These metal push buttons are a very tough, small, panel-mount momentary sw...

This 2m long One Wire Temperature Sensor has a waterproof probe and long wire shape, suitable for immersive temperature detection. The chip inside ...

E' disponibile la nuova versione:  ETH008-B - 8 relay outputs at 16A   OverviewThe ETH008 provides eight volt free contact relay outputs with a cu...

This is a breakout board for Honeywell's HIH-4030 humidity sensor. The HIH-4030 measures relative humidity (%RH) and delivers it as an analog out...

Face it, if you keep this up your workbench is going to turn into a galaxy of small parts with no place for anything and nothing in its place. Okay...