MAGENTO IMPORT

So squishy! These silicone elastomer keypads are just waiting for your fingers to press them. Go ahead, squish all you like! (They're durable and e...

Grove - Bee Socket is an adaptor of Xbee serials which can connect wireless modules with Arduino, such as WIFI Bee, RF Bee, Bluetooth Bee, etc. It ...

EL Inverters, if you are wanting to doanything with EL lighting you need one, period. This 3V EL Inverter is a special type that is intended to be ...

If you need to add user input without using a button, then a capacitive touch interface might be the answer. The AT42QT1010 Capacitive Touch Breako...

  Grove - I2C ADC is a 12-bit precision ADC module based on ADC121C021. It helps you increase the accuracy of value collected from analog sensor b...

Cavo di ricarica con attacco DEANS

  While our small diagonal cutters are great for hobby use, sometimes you need something with a little more bite. These electronic snippers are gre...

This 350cm Phidget Cable connects: analog sensors to Phidgets with an analog input or VINT Hub port. VINT devices to Phidgets with a VINT Hub port...

SIX POLES MAGNET:THREE PULSES FOR MOTOR TURN HALL-EFFECT SWITCHES These Hall-effect switches are highly tempertature stable and stress-resistant s...

This breadboard-compatible module is an alternative to bulky power switches. It uses a small integrated slide switch to control a high-side power ...

The eTape Liquid Level Sensor from Milone Technologies is a great way to measure the level of a liquid. It has a resistive output that varies with ...

The EGM30 (encoder, motor, gearbox 30:1) is a 12v motor fully equipped with encoders and a 30:1 reduction gearbox. It is ideal for small or medi...

The USB-RLY16 provides eight volt free contact relay outputs with a current rating of up to 16Amp each. The processor is powered and instructed fr...

Snap, snap! The NoIR Camera v2 is the official "night vision" camera board released by the Raspberry Pi Foundation! The Raspberry Pi NoIR Camera Bo...

The 7” Touchscreen Display for Raspberry Pi gives users the ability to create all-in-one, integrated projects such as tablets, infotainment systems...

This it the SparkFun RFID Starter Kit, an all-in-one kit that offer everything you need to get your next RFID project off the ground. This kit incl...

Make your own USB connections without slicing apart a USB cable and soldering those thin wires inside. These DIY "USB shells" are available in USB ...

The AD8232 Single Lead Heart Rate Monitor is a cost-effective board used to measure the electrical activity of the heart. This electrical activity ...

Put a current meter anywhere with this very handy display. This panel meter requires a DC voltage to run, and then has two thick gauge wires to mea...

  This is a basic RFID tag that functions within the MIFARE Classic 1K guidelines. You can use these for all sorts of identification and sensing ...

This is a simple slide switch for the LilyPad. Use it as a simple ON/OFF switch, or to control LEDs, buzzers, sensors, etc. LilyPad is a wearable...

This is an inner thread (outer nut) adapter that will connect to any of our wireless boards or interface cables and allow you to use an antenna/ca...