WRTnode Standard Shield

• Be sure to plug the WRTnode into the shield as the picture, Be sure DONOT go wrong direction.
• For the power we recommend a 5V USB-interface adapter higher than 1000mA, when more USB devices plugged in, we recommend a 2A or 2.5A adapter, such as your ipad one.
• How to with U-Boot web-page fail-safe de-brick button:
• An original WRTnode U-Boot WRTnode_U-Boot_instructions will provide this, if there's another U-Boot have been flashed, this section is invalid.

• Set your computer Ethernet with the IP: 192.168.1.100 and the mask: 255.255.255.0, connect computer and the shield with RJ45 wire.
• Push the button(in this case to prevent misoperation, we use a very tight button, please make sure to hold the button tightly with nail or blunt object.)
• Power on
• WRTnode sense the pushed button, the led indication on WRTnode will flash for about 5 seconds.

• 5V micro-USB DC-in
• Extend 4 standard USB port
• 1 RJ45 100M Ethernet port( to be a LAN port or WAN port as you define)
• other interfaces:
• UART
• I2C( while could multiused as GPIO * 2)
• SPI
• GPIO*12
• Uboot web-page fail-safe de-brick button
• 5v and 3.3v pins

Documents