Products

Bus Blaster v4 is an experimental, high-speed JTAG debugger from Dangerous Prototypes. Thanks to a reprogrammable buffer, a simple update over U...

The Bus Pirate v3.6a, created by Ian Lesnet, is a troubleshooting tool that communicates between a PC and any embedded device over 1-wire, 2-wire,...

The Bus Pirate v3.6a, created by [Ian Lesnet](http://dangerousprototypes.com/), is a troubleshooting tool that communicates between a PC and any em...

This is an interface cable designed for Bus Pirate which can makes it easier to connect the Bus Pirate to a circuit and get hacking!

This is an interface cable for the Bus Pirate, designed to connect to its 2x5 I/O header. The cable's connector is composed of two rows of five 0.1...

This is an interface cable for the [Bus Pirate](http://www.sparkfun.com/commerce/product_info.php?products_id=9544), designed to connect to its 2x...

Bus Pirate v3 is a universal bus interface that talks to electronics from a PC serial terminal. Get to know a chip without writing code. Elimina...

This small capsule is a 4.5V button cell battery holder for mini power solutions.Its minimalism design in clean white cylinder body and matte surf...

Cute as a button, these button-head hex screws are what we suggest for putting together a project with our slotted extruded aluminum. Use a 2.5mm ...

Cute as a button, these button-head hex screws are what we suggest for putting together a project with our slotted extruded aluminum. Use a 2.5mm h...

This compact load cell measures compressive forces. Calibration certificate included.

This compact load cell measures compressive forces. Calibration certificate included.

This compact load cell measures compressive forces. Calibration certificate included.

This is a simple breakout board for the button pads. Each LED and button is brought out to the side connectors. The connectors are soldered to the...

This a simple breakout PCB for our [2x2 silicone button pads](https://www.sparkfun.com/products/7836). Each LED and button is brought out to the si...

This is a translucent silicon rubber button pad with 4 buttons orignally inspired by the folks at monome.org . Each button has a hole underneath t...

This is a translucent silicon rubber button pad with 4 buttons orignally inspired by the folks at [monome.org](http://monome.org). Each button has...

This is a black plastic bezel, custom made to mate with the silicon rubber pads. Black 1/8" ABS plastic. Using two of these bezels with two of the...

This is a black plastic bezel, custom made to mate with the silicon rubber pads. Black 1/8\" ABS plastic. Using two of these bezels with two of th...

This is a black plastic bezel, custom made to mate with the silicon rubber pads. Black 1/8" ABS plastic. We use four 4/40-0.5" size screws matched ...

This is a black plastic bezel, custom made to mate with the silicon rubber pads. Black 1/8\" ABS plastic. We use four 4/40-0.5\" size screws matche...

This is a simple breakout board for the button pads. Each LED and button is brought out to the side connectors. The connectors are soldered to the...

This a simple breakout PCB for our [4x4 silicone button pads](https://www.sparkfun.com/products/7835). Each LED and button can brought out to the ...