Products

USB-RLY82 case. Includes mounting holes for fixing to a wall or back panel. This precision snap together case includes screws for mounting the USB...

The USB-RS485 module provides an easy to use RS485 interface by means of a Virtual Com Port on the users system. There are no command structure...

The USB-RS485 is a complete, self-powered, USB to RS485 interface working at any baud rate up to 250k baud. It features automatic bus turn-around ...

FEATURES: USB to serial cable three wires for Breadboard connection SERIAL output 3.3V voltage levels GND=BLUE, RX(INPUT)=GREEN, TX(O...

Utilizing the fantastic AMG8833 thermopile array from Panasonic, the TPA64 offers an economical but powerful temperature imaging solution. ...

A low cost and very compact Li-Po battery charger, based on Microchip MCP73833 with three status LEDs for displaying the battery status, works wit...

This USB cable adds a DB9 serial port to your computer or laptop. Works with MacOS Note that this provides (approximately) +-6V serial (RS232) not...

USB/TTL Raspberry Pi GPS tracker is a small GPS location module. It is using L80-39 GPS chip, which includes 66 search channels and 22 simultaneous...

This is a USB AVR programmer supported by official Arduino IDE. Once the Arduino has lost its bootloader for some reasons, use this programmer to r...

USBtinyISP is a simple open-source USB AVR programmer and SPI interface. It is low cost, easy to make, works great with avrdude, has both 6 and 10 ...

The Useless Box is now sporting 4 metal hinges to hold the lids in place instead of our previously tacky tape. Yes, it's ... Useless! Designed a...

Need some really bright LEDs? We are big fans of these 5mm clear UV / Purple LEDs. These emit UV 'blacklight' in the UVA spectrum so they are grea...

This is a UVC ultraviolet germicidal lamp strip with a wavelength of 275nm, belonging to short-wave ultraviolet rays, with strong germicidal abilit...

This vacuum pump really sucks! This pump operates at 12V and has enough suction for most small projects. We even used one to make our very own [uni...

Apply heat to the solder joint with the solder tool to soften it for the suction device. Have the suction ready to go as soon as the solder is suff...

Apply heat to the solder joint with the solder tool to soften it for the suction device. Have the suction ready to go as soon as the solder is suff...

The VClamp allows RoboClaw and MCP motor controllers to be used with switching power supplies by dissipating excess regenerative energy through a c...

The VCNL4010 sensor is a nice way to add a small-distance proximity sensor to your microcontroller project. For longer distances (in the range of c...

The VCNL4010 sensor is a nice way to add a small-distance proximity sensor to your microcontroller project. For longer distances (in the range of ...

This clip-on current transducer provides a quick and easy way to measure up to 25A of DC current running through a wire without cutting or disasse...

The smallest, most powerful, and most versatile GPS receiver we carry just got more powerful.The Venus638FLPx is the successor to the Venus634LP...