Catalogues

TRRS connectors are the audio-style connectors that you see on some phones, MP3 players and development boards. TRRS stands for \"Tip, Ring, Ring,...

These are the sturdy little stomp switches that you find on guitar effects pedals. They're 3PDT (three-pole, double-throw) type switches. These sw...

Are you looking to add a lot of color to your project? These massive 32x32 RGB LED panels are an awesome place to start. You can create animations...

The SN74HC595N is a simple 8-bit shift register IC. Simply put, this shift register is a device that allows additional inputs or outputs to be adde...

Sometimes when you have too many choices, it\'s hard to make a good decision. In fact, there are times when you just want a bag of LEDs, just one o...

A simple slide potentiometer can go a long way. Rated at 10KOhm and 0.1W. Comes with solder tab connections. The pot has an overall travel of 30mm...

This simple on-off switch is rated for 20A at 12V but who cares about all that, it looks way awesome. These toggle switches come with those missile...

These DC powered heating pads are perfect for near-body heating applications. They get warm to the touch but not too hot as long as you provide the...

This little round on/off toggle switch is rated up to 10A at 125VAC and can be panel mounted in a 20mm diameter hole. It\'ll also look pretty slic...

Ever hear of a thing called RGB? Red, Green, Blue? How about an RGB LED? These 5mm units have four pins: one for each color and a common anode. Use...

This plastic knob accepts a 6mm shaft and has a 15mm outer diameter. They simple press-fit onto a shaft. These are clear so that they can be used ...

The seven band graphic equalizer IC is a CMOS chip that divides the audio spectrum into seven bands. 63Hz, 160Hz, 400Hz, 1kHz, 2.5kHz, 6.25kHz and ...

These 10 segment bar graph LEDs have many uses. With a compact footprint, simple hookup, they are easy for prototyping or finished products. Essen...

There are lots of trimpots out there. Some are very large, some so small they require a screwdriver. Here at SparkFun, we just needed a simple one...

This is a joystick very similar to the \'analog\' joysticks on PS2 (PlayStation 2) controllers. Directional movements are simply two potentiometers...

These are small rare earth magnets - 3/16\" rings. Composed of Neodymium/Iron/Boron (NdFeB), these magnets are curiously strong and make for a gre...

These are small rare earth magnets - 0.25\" cubed. Composed of Neodymium/Iron/Boron (NdFeB), these magnets are curiously strong and make for a grea...

Small electret microphone. Useful in acoustic and audio applications. **Documents:** * [Datasheet](http://cdn.sparkfun.com/datasheets/Sensor...

This is a small 12mm round speaker that operates around the audible 2kHz range. You can use these speakers to create simple music or user interfac...

This is a translucent silicon rubber button pad with 4 buttons orignally inspired by the folks at [monome.org](http://monome.org). Each button has...

These are very common, high quality BJT NPN transistors made by ST Micro. **Documents:** * [Datasheet](http://www.sparkfun.com/datasheets/Com...

We use these little buttons on everything! These Miniature Single Pole Single Throw switches have a good click to them and are breadboard friendly...

This is a basic RP-SMA (Reverse Polarity Sub-Miniature A) male to female connector cable. Each cable is 10M (393.7in.) long with RG58 housing. The ...

This panel mount USB-C extension cable enables you to more easily enclose a project that contains a USB-C port. The cable is 6" in length and incl...