Catalogues

Designing boards with plug-n-play connectivity is a snap, with STEMMA connectors. Here's a pack of 10 of our favorite 2mm pitch connector which ar...

We're with the squad back at New York's hottest cyberpunk club, Near Field Commune(ication), and it's still got everything , Adabot & the Circu...

This audio adapter lets you easily add high quality 16 bit, 44.1 kHz sample rate (CD quality) audio to your projects with Teensy 4.0 ( Rev D2 , as...

It's rare to see breadboard friendly I2C sensors, but this TO-220 package with 5 pins is, in fact, such a thing! It's a basic temperature sensor, ...

Trends come and go, but preparedness is always in fashion! Have you ever been in a situation where you desperately needed a screwdriver right away...

We have all sorts of LED strips for a wide range of needs. Chonky strips? We got those! Strips with alligator clips that are easy-peasy to MakeCod...

Just about all electronics use a UART serial port with RX and TX pins for debugging, bootloading, programming, serial output, etc. But it's rare f...

We are very excited to carry a new book by Adafruit Learning System author and maker Kathy Ceceri ! Robots are everywhere! They vacuum our houses,...

Pipe audio in or out of your project with this very handy panel mount audio jack. It's a mono jack with a disconnect pin so you'll get a ground sle...

This 9-pin cable is just about 100mm / 4" long and fitted with JST-SH female connectors on both ends. Compared with chunkier JST-PH these are 1mm p...

We are very excited to carry a new book by Adafruit Learning System author and maker Kathy Ceceri ! Robots are everywhere! They vacuum our houses,...

Meet the affordable 8 Channel LoRa gateway from TTN, The Things Indoor Gateway ! Simple name for a straight-to-the point product. It's the new low...

Ready Players 1 and 2? Double up on your MakeCode gaming with a Sync Cable ! We got this Micro B USB to Micro B USB cable specially made to connec...

Looking for a way to keep your Raspberry Pi 4 running cool and also looking cool? We've got a two-birds-one-stone solution for you. This enclosure...

Looking for a way to keep your Raspberry Pi 4 running cool and also looking cool? We've got a two-birds-one-stone solution for you. This enclosure...

This cable is a little over 100mm / 4" long and fitted with JST-PH 3-pin connectors on either end. We dig the solid and compact nature of these c...

If you're a DIY enthusiast who likes to micro -manage your project's connections, here is a 10-pack of some micro 1mm pitch connectors that are JS...

This tiny little servo can rotate approximately 180 degrees (90 in each direction), and works just like the standard kinds you're used to but small...

Who else could pack a 600 MHz microcontroller into such a Teensy little board? The Teensy 4.0 features an ARM Cortex-M7 processor at 600 MHz, with...

You love NeoPixels, and you love silicone diffusion? Peep this Flexible Silicone Neon-like Skinny NeoPixel LED Strip ! OK it's a bit of a mouthful,...

This is hot! Literally! Apply 5-12VDC and the stainless steel fibers in this heating fabric will warm up, creating a little heating pad. On one han...

When working with unusual non-header-friendly surfaces, these handy cables will be your best friends! No longer will you have long, cumbersome stra...

ΩMG! You're not going to be able to resist these handy resistor packs! Well, axially, they do all of the resisting for you! This is a 25 Pack of 1...

ΩMG! You're not going to be able to resist these handy resistor packs! Well, axially, they do all of the resisting for you! This is a 25 Pack of ...