Catalogues

Need some really bright LEDs? We are big fans of these clear white LEDs, in fact we use them exclusively in our kits. They are very bright and have...

This 1.27mm pitch, 2x5 male SMT Box Header is the same one used on our SWD Cable Breakout Board . The header alone is great if you want to incorpor...

Secure your project with biometrics - this all-in-one optical fingerprint sensor will make adding fingerprint detection and verification super simp...

Outdoor enthusiasts rejoice! We now have standard 5.5/2.1mm DC power cable sets in a waterproof variety. These cable sets are ideal for projects t...

RGB Pixels are digitally-controllable lights you can set to any color, or animate. Each RGB LED and controller chip is molded into a 'dot' of silic...

Imagine terminal blocks that are cut out of one solid piece of brass, designed to distribute power. Well, that's what we have here! These machined...

With a slip ring assembly, your electronics can now twist and turn safely. Add wheel encoders, 360 degree sensors, rotating LEDs, rotors and more!...

If you want to make a kit you'll need some solder. This 1/4 lb (about 110 gram) spool is just the right amount, not too much (like 1 lb spools) an...

Add another 16 pins to your microcontroller using an MCP23017 port expander. The MCP23017 uses two i2c pins (these can be shared with other i2c dev...

We have so many Internet-connected goodies in the shop, we figured it's time to carry a cable so you can easily connect them up! This cable is 10 f...

Nothing makes a project harder to maintain than a lot of loose wiring. That's why we like to use terminal blocks whenever making PCB-to-Wire connec...

Nothing makes a project harder to maintain than a lot of loose wiring. That's why we like to use terminal blocks whenever making PCB-to-Wire connec...

Stack to the max with our Beagle Bone Proto Cape using these ingenious stacking headers. They're just like 2x23 0.1" spaced female headers but with...

Put a voltage meter anywhere with this very handy display. These are often used by RC hobbyists for keeping track of batteries but we thought it w...

These surface-mount LEDs are an easy way to add a lot of bright white dots to your project. They're similar to the ones in our digital RGB LED str...

These are very interesting 5mm diffused RGB LEDs - instead of having 4 pins to control 3 LEDs, they have only two leads - power and ground. When po...

Connect this to that without soldering using these quick terminal blocks. They allow connecting two sets of four wires together using just a flat-h...

A little bundle to get you started! This project pack contains: 5 meters (over 16 ft) of welted EL wire piping in Aqua . 5 meters is the maxi...

EL Wire, also known as Electroluminescent wire is a stiff wire core coated with phosphor and then covered with a protective PVC sheath. When an AC...

A perfect match for our sew-able coin cell holder . This non-rechargeable coin cell is CR2032 sized: 20mm diameter, 3.2mm thick. It has a nominal ...

This battery holder is by far the easiest way to add a battery to a small wearable project. By coincidence, there are two small 1mm diameter holes...

As electronics get smaller and smaller, you'll need a hand examining PCBs and this little USB microscope is the perfect tool. Its smaller and light...

Get glowing in seconds with our Electroluminescent (EL) Tape Starter Pack! This pack contains everything you need for your first EL tape project, ...