Devantech

dS2832 houses. Includes mounting holes for fixing to a wall or back panel. This precision snap together case includes screws for mounting the dS283...

Controlled over WIFI using preprogrammed command sets or html page. Relays - 8 x 1A 30v outputs using a 50mW ultra efficient relay Inputs - 8 x op...

The ETH0621 offers 6 digital inputs (accepting 10V - 24V), 2 independently switched 24V 5A outputs and a 24 volt, 5A motor controller that effortl...

WARNING Mains Voltages can be Lethal. If you are not confident with using these voltages, please use a qualified electrician to wire this up for y...

The MIDI-RLY8 provides 8 relay outputs that respond to midi note or control change messages, these can be either mechanical or solid state relays....

The MIDI-RLY8 provides 8 relay outputs that respond to midi note or control change messages, these can be either mechanical or solid state relays....

Developed in collaboration with Manu Systems , the WOR-R1 is a solid research base carrying the RD02 robot drive. There are slot cutouts in the bas...

The CM02 module, together with its companion RF04 module, form a complete interface between your PC and our range of I2C modules. You can send com...

3 by 4 Keypads. (Telephone type) You can use this 3x4 keypad to customize to your application! Size: 1.72" x 2.63" (43.8 x 66.7mm)

Controlled over Ethernet using simple TCP/IP commands. Relays - 20 Analogue Inputs (0-5v) - 16 Power - 12V DC adapter, supplied separately. Conf...

Controlled over Ethernet using simple TCP/IP commands. Relays - 10 Analogue/digital inputs - 16 inputs at 5v 10 analogue conversion or will repo...

Simple configuration and setup from your web browser. Control it from a web page, or select tcp/ip control with an option of ASCII, Binary or Modb...

Expansion board for the dScript modules providing low voltage DC inputs (analogue or digital) and two extra relays, powered and controlled through...

Expansion board providing 230VAC opto inputs and two extra relays for the dScript modules, powered and controlled through the dS modules RS485 por...

Expansion K type Thermo-couple board and 2 extra relays for the dScript modules, powered and controlled through the dS modules RS485 port. Hardw...

The USB-RS485 is a complete, self-powered, USB to RS485 interface working at any baud rate up to 250k baud. It features automatic bus turn-around ...

The WLED03 is a WIFI connected PWM driver for 12v LED strip lights using the popular ESP32. It provides 3 channels driving up to 3 Amps each. Powe...

The MIDI-RLY8 provides 8 relay outputs that respond to midi note or control change messages, these can be either mechanical or solid state relays. ...

RoboSpine does for your robot what your spinal chord does for you. It connects eyes and ears to the brain and the brain to the muscles. RoboSpine ...

The BT004BLE provides four volt free contact relay outputs with a current rating of up to 16Amp each controlled over a HM10 Bluetooth serial port....

Controlled by modbus RTU over RS485, address, baud rate and parity set by dip switch. Relays - 8 VFC with snubbers on N/O Digital opto isolated in...

USB-RLY82 case. Includes mounting holes for fixing to a wall or back panel. This precision snap together case includes screws for mounting the USB...

Ruggedised, Industrial, DIN rail mounting control module Built in snubbers for safe connection to inductive loads. Optically isolated inputs. Main...

Servant Channels - up to 84 Logic Outputs - up to 84 Logic Inputs - up to 84 10-bit Analog...