DFRobot

This kit includes two kinds of mini multi-color block building breadboards and 2 base plates of different sizes. Users can freely assemble these b...

This barometric pressure temperature sensor is equipped with TDK's newly launched ICP-10111 barometric pressure sensor, which is based on MEMS capa...

This is a breakout version of BMP280 Barometric Pressure Sensor from DFRobot with temperature and pressure measurement functions, supporting Ardui...

This barometric pressure temperature sensor is equipped with TDK's newly-launched ICP-10111 barometric pressure sensor, which is based on MEMS cap...

This high-resolution differential pressure breakout board with I2C communication is used to measure the difference in pressure across two points o...

This new released BMP388 barometric pressure sensor by DFRobot is equipped with the functionality of temperature and pressure measurement. It suppo...

This is a newly-introduced Breakout version of BMP388 Sensor from DFRobot with pressure and temperature measurement. It supports Arduino code cont...

This is an Arduino compatible pressure sensor module with a measuring range of 15-700kPa, which supports I2C digital output and can be calibrated a...

This is a force sensitive resistor with a round, 0.5" diameter, sensing area. This FSR will vary its resistance depending on how much pressure is b...

This is a piezoresistive force sensor. The harder you press, the lower the sensor's resistance. Pressing lightly, the resistance changes from infin...

This is a piezoresistive force sensor. The harder you press, the lower the sensor's resistance. Pressing hard, the resistance changes from infinite...

This is a small force sensitive resistor. It has a 0.16" (4 mm) diameter active sensing area. This FSR will vary its resistance depending on how mu...

Classic 9V connector terminated with 2-pin polarized Molex connector. 15cm in length. To supply the power to Arduino, we recommend the DC Powe...

This adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5x2.1mm, center-positiv...

This battery holder can hold 6 AA battery which can make 7.2 V rechargeable battery pack from NiMH / NiCd cells or 9V battery pack from alkaline c...

This is the second version of the 9V to Barrel Jack Adapter. In this version the material for the 9V battery jack is hard plastic, which makes it ...

This small capsule is a 4.5V button cell battery holder for mini power solutions.Its minimalism design in clean white cylinder body and matte surf...

This battery holder can hold 6 AA battery which can make 7.2 V rechargeable battery pack from NiMH / NiCd cells or 9V battery pack from alkaline ce...

This Solar lipo charger is designed for single Lithium battery (3.7V) for intelligent charging, with input reverse polarity protection. The maximum...

Simple 4 Cell AA Battery holder with 5" tinned leads, square configuration. This holder features a sliding, removable cover as well as an ON/OFF sw...

This simple cable has so many uses! Plug a 9V battery into one end and connect the other end to anything with a 5.5x2.1mm, center-positive barrel ...

A nice portable power pack can help you a lot when you build up your projects. Come and make one with this 3×AAA battery holder. This is a 3xAAA B...

A nice portable power pack can help you a lot when you build up your projects. Come and make one with this 3×AA battery holder. It can fit three A...

This is a 7.5V wall adapter. It is not commonly available in the market. The best part of this adapter is that it allows Arduino project to run ind...