DFRobot

Wireless charging modules uses an electromagnetic field to transfer energy between two objects. This is usually done with a charging station. Energ...

Note: This kit includes Raspberry Pi Compute Module 4 IoT Router Carrier Board Mini , Acrylic Case with Heatsink for CM4 IoT Router Carrier Board ...

Compute Module 4 IoT Router Carrier Board Mini is an internet expansion board based on the Raspberry Pi Compute Module 4. When connecting with a gi...

This IV-18 VFD tubes Clock (Energy Pillar) is a fully assembled and calibrated IV-18 VFD clock. It displays hour, minute, second. Eight digi...

This immersible pump can be used to water your plants, make a fountain or waterfall, even change your fish tank water. It comes with an inlet valve...

The module adopts the standard Modbus RTU protocol, the communication interface supports RS485 or RS232 and supports communication baud rates of 2...

After purchasing an open-source product that is not electrical level compatible, you may find that your sensor cannot work normally or even is eas...

If you have tried our 64×64 or 64×32 RGB LED Matrix Panel, but you had to give up some of your original ideas and designs out of the limitation of ...

This is a miniature servo that can be connected in series, which can be controlled individually or in a unified manner through TTL serial communica...

After purchasing an open-source product that is not electrical level compatible, you may find that your sensor cannot work normally or even is easy...

Use this 12V solenoid valve to control the flow of liquid! This is an automated and manual solenoid valve that comes with three colors control wire...

Use this 12V solenoid valve to control the flow of liquid! This is an automated and manual solenoid valve that comes with three colors control wire...

This is a dual channel DC motor driver with an extremely small size of 1.97”×1.97”×0.49”. The module comes with two motor channels that can drive t...

This is a waterproof DC-DC converter. With 8-40V DC input, it converts to 24V@6A which is an ideal supply for mobile robots, and motors.

SIM8262A-M2 is a 5G wireless communication module that supports 5G NR (NSA/SA), LTE-FDD, LTE-TDD, and WCDMA, and can meet the 3GPP R16NR specifica...

A Magnetic latching relay is a new type of relay. It features low power dissipation and noiseless. Unlike other non-latching relay, the latching re...

Connect your Arduino device to the Internet with this Ethernet Shield. This Ethernet Shield is based on the W5200 Ethernet Chip and provides an eas...

SIM8262E-M2 is a 5G wireless communication module that supports 5G NR (NSA/SA), LTE-FDD, LTE-TDD, and WCDMA, and can meet the 3GPP R16NR specifica...

M.2 (A+E Key) to Gigabit Ethernet Module compatible for LattePanda Alpha and Delta . This M.2 Gigabit Ethernet Adapter can switch out an RJ45 Gi...

This is a waterproof DC-DC converter. With 8-18V DC input, it converts to 24V@10A which is an ideal supply for robots. Notes : Input voltage o...

A low power version of the USB-RLY16 module, the USB-RLY16L is powered solely by the USB bus and provides eight volt free contact relay outputs wit...

This is an embedded serial-to-Ethernet module based on the ESP32 series, also can be called a gateway. The module integrates an optimized TCP/IP pr...

The ETH008-B provides eight volt free contact relay outputs with a current rating of up to 16Am. The module is powered from a 12vdc supply which ca...

This equipment based on the Raspberry Pi technology is designed for professional use. This PLC has up to 36 Digital Inputs, 16 Analog Inputs, 8 ...