DFRobot

Breakout board for the Analog Device ADXL345. The ADXL345 is a small, thin, low power, 3-axis accelerometer with high resolution (13-bit) measurem...

This Triple Axis Accelerometer with Bosch BMA220 is an ultra small triaxial, low-g acceleration sensor breakboard with SPI and I2C interface, aimin...

At the beginning, the inertial measurement unit is an electronic device that measures and reports on a craft's velocity, orientation, and gravitat...

The LSM303DLH is a triple axis accelerometer combined with a triple axis magnetic sensor. This breakout board uses the LSM303DLH to give you the d...

The BMI160 6-axis inertial motion sensor is a new product from DFRobot. It is based on Bosch BMI160 6-axis MEMS sensor which integrates 16-bit 3-a...

BNO055 is a new sensor IC for implementing an intelligent 9-axis Absolute Orientation Sensor. It is a System in Package, integrating a triaxial 14-...

This module integrates high-precision gyroscopes, accelerometer, microprocessor of high-performance and advanced dynamics solves and Kalman filter...

The BMM150 is a low-power and low noise 3-axis digital geomagnetic sensor that perfectly matches the requirements of compass applications. Based on...

The H3LIS200DL is a high-performance triple-axis linear accelerometer with an ultra-low power consumption of 10uA. It offers user-selectable scale...

This compact BMX160 9-axis sensor from Bosch Sensortec is an ideal solution for applications that face strict constraints of board space, power co...

DFRobot presents the ultra low-power Arduino triple axis accelerometer! This device is based around a MEMS LIS2DH chip solution and has high-perfor...

The LIS331HH is an ultra-low-power high precision triple-axis linear accelerometer with 16-bit data output. It has user selectable full scales of ±...

The H3LIS200DL is an ultra low-power(down to 10uA) and low noise 3-axis accelerometer. It has user selectable scales of ±100g/±200g and is capable ...

The LIS2DW12 is an ultra-low-power high-performance three-axis linear accelerometer. It has user-selectable full scales of ±2g/±4g/±8g/±16g and is ...

The LIS2DW12 is a low power high-performance three-axis linear accelerometer, featuring low power (50 nA), low noise (1.3 mg RMS), 32 FIFO, ±2g/±4...

The ICG-20660L is a high-precision 6-axis IMU module that integrates a 3-axis accelerometer(±2/4/8/16g), a 3-axis gyroscope(±125/250/500dps), and ...

This is a three axis accelerometer for the LilyPad system. Based on the ADXL335 accelerometer from Analog Devices, the LilyPad Accelerometer can d...

This is a package of crimp pins for female housing pins with the pitch of 2.54mm(0.1"). You can make customized cables that mate with the 0.1"-s...

This wire connector set is made by flame retardant material. It works very well in extreme environments.

This is quality DB9 Male Connector that with solder tail package. DB9 connector is widely used for serial communication RS232, RS485 and RS422 inte...

This is quality DB9 female Connector that with solder tail package. DB9 connector is widely used for serial communication RS232, RS485 and RS422 i...

A row of right angle headers - break to fit. 40 pins that can be cut to any size. Used with custom PCBs or general custom headers.

This is a blue colored 40 Pin 2.54 mm（0.1"） single row pin header strip from DFRobot. These 0.1" header strips are commonly used as low-cost Ardu...

This is a 1-pin female housing pin with the pitch of 2.54mm(0.1"). You can make customized cables that mate with the 0.1"-spaced pins. NOTE: Doe...