MAGENTO IMPORT

This is a 10-pin female header, with extra long legs -- great for stacking R3-compatible Arduino shields! Pins are spaced by 0.1". Documents: ...

This is an 8-pin female header, with extra long legs -- great for stacking Arduino shields. Pins are spaced by 0.1". Documents: Datasheet

This is a 6-pin female header, with extra long legs -- great for stacking Arduino shields. Pins are spaced by 0.1". Documents: Datasheet

The name says it all on this one. An ATmega328 in DIP package, pre-loaded with the Arduino Optiboot (Uno 16MHz) Bootloader. This will allow you...

These are 6" long jumper wires terminated as male to female. Use these to jumper from any male or female header on any board. Multiple jumpers can ...

The RHT03 (also known by DHT-22) is a low cost humidity and temperature sensor with a single wire digital interface. The sensor is calibrated and ...

The TMP36 is a low voltage, precision centigrade temperature sensor. It provides a voltage output that is linearly proportional to the Celsius t...

Resistors are a good thing, in fact, they're actually crucial in a lot of circuit designs. The only problem seems to be that resistors disappear...

It's blue! It's thin (0.8mm)! It's the Arduino Pro Mini! SparkFun's minimal design approach to Arduino. This is a 5V Arduino running the 16MHz boo...

This simple cable has so many uses! Plug a 9V battery into one end and connect the other end to anything with a 5.5x2.1mm, center-positive barre...

Standard 22 AWG solid Black hook up wire. Use this with your bread board or any project where you need sturdy wire. Comes in small spools of 25'.

We've been prototyping for a long time on these awesome little plastic plates but it's time for an upgrade. This version still holds an Arduino and...

Standard 22 AWG solid red hook up wire. Use this with your bread board or any project where you need sturdy wire. Comes in small spools of 25'.

This is a simple two wire cable. Great for jumping from board to board or just about anything else. There is a 2-pin JST connector on one end, b...

This is a simple two wire cable. Great for jumping from board to board or just about anything else. There is a 2-pin Molex connector with 0.1" s...

These are 150mm long jumpers terminated as male to female. Use these to jumper from any male or female header on any board. Multiple jumpers can ...

Ribbon cable is really helpful in situations where you need to make a lot of connections without a big mess of wires. Nothing makes a project lo...

Description: Screw Terminals with 3.5mm pitch pins. Comes in 2 or 3 positions and have the really cool feature of slide-locking together to form a...

Ribbon cable is really helpful in situations where you need to make a lot of connections without a big mess of wires. Nothing makes a project lo...

These are 6" long jumper wires with male connectors on both ends. Use these to jumper from any female header on any board, to any other female head...

This is the latest DS18B20 1-Wire digital temperature sensor from Maxim IC. Reports degrees C with 9 to 12-bit precision, -55C to 125C (+/-0.5C). ...

This sealed digital temperature probe lets you precisely measure temperatures in wet environments with a simple 1-Wire interface. The DS18B20 prov...

Standard 22 AWG solid yellow hook up wire. Use this with your bread board or any project where you need sturdy wire. Comes in small spools of 25'.