MAGENTO IMPORT

It's your basic black action button! This is a very useful, small, panel-mount momentary switch. It is a SPST NO with 1/4" threading. This button ...

Simple shrouded 10-pin connector. Good for preventing cable connection mishaps. Use for programming, data, power, or any other kind of connectio...

Simple breakout board for the MQ - 3, MQ - 4, MQ - 6 and MQ - 7 gas sensors. All you need is VCC at 5V, GND, and a resistor to an ADC, that is it....

These are 150mm long jumpers with male connectors on both ends. Use these to jumper from any female header on any board, to any other female head...

This is similar to other 16x2 character LCDs that you've seen before but with one vibrant difference: The backlight is actually an RGB LED. This m...

This is a simple 6 wire cable. Great for jumping from board to board or just about anything else. They have bare wires on one end and a 6-pin JS...

This is a simple 4 wire cable. Great for jumping from board to board or just about anything else. They have bare wires on one end and a 4-pin JS...

This is a perfect choice if you are in need of a heavy duty push button! These metal push buttons are a very tough, small, panel-mount momentary s...

This is a breakout board for Honeywell's HIH-4030 humidity sensor. The HIH-4030 measures relative humidity (%RH) and delivers it as an analog ou...

Face it, if you keep this up your workbench is going to turn into a galaxy of small parts with no place for anything and nothing in its place. Oka...

These are 150mm long jumpers terminated as male to female. Use these to jumper from any male or female header on any board. Multiple jumpers can b...

Face it, if you keep this up your workbench is going to turn into a galaxy of small parts with no place for anything and nothing in its place. Oka...

Testing surface-mount components with standard test leads is anything but easy. Everyone has their own method: some people tackle it with teamwork...

These are simple through-hole RJ45 sockets with PCB mounting posts. These 8-pin connectors are commonly used in conjunction with Cat5, Cat5e, and ...

RJ45 connectors are the kind that are used for Ethernet jacks, but they make great general purpose connectors when you need a lot of conductors. Th...

Thanks to their square shape, these RGB LEDs can sit flush against a PCB saving you precious vertical space in projects where space is a luxury. Th...

Sometimes when you have too many choices, it's hard to make a good decision. In fact, there are times when you just want a bag of LEDs, just one of...

These 2x5 crimp connectors can be snapped onto 10-wire ribbon cable to make your own cable assemblies and keep your connections organized. Simpl...

The 'must have' IC for TTL/CMOS projects finally has its own breakout board! This is the RS232 converter IC that is capable of running at 3V and co...

This is a simple 6 wire cable. Great for jumping from board to board or just about anything else. There is a 6-pin JST RE connector on both ends...

This is a simple 6 wire cable. Great for jumping from board to board or just about anything else. There is a 6-pin JST RE connector on both ends...

A simple slide potentiometer can go a long way. Rated at 10KOhm and 0.1W. Comes with solder Jul connections. The pot has an overall travel of 30mm...

There's nothing worse than getting ready for a good hack and then realizing that you can't even get the box open because you don't have the righ...

These 2x3 crimp connectors can be snapped onto 6-wire ribbon cable to make your own cable assemblies and keep your connections organized. Simply...