MAGENTO IMPORT

This is a breakout board for the SP3485 RS-485 transceiver IC, which will convert a UART serial stream to RS-485. The SP3485 is a half-duplex tran...

This tiny audio amplifier is based on the Texas Instruments TPA2005D1. Its efficient class-D operation means low heat and long battery life. It ca...

This connector cable interfaces UFL RF connectors to RP-SMA antennas. Use it to attach any standard RP-SMA 2.4GHz antenna to the DPAC 802.11 mod...

This is a 3-terminal microswitch two pack, each equipped with a 20mm offset lever actuator. These switches have a great 'clicky' sound to them with...

These small steppers are a great way to get things moving, especially when positioning and repeatability is a concern. This is a Bipolar motor. ...

It's your basic blue action button! This is a very useful, small, panel-mount momentary switch. It is a SPST NO with 1/4" threading. This button i...

We've been using and selling Analog Devices' ADXL accelerometers for a good while now, and now we've found another great part in the series! The A...

These 10 segment bar graph LEDs have many uses. With a compact footprint, simple hookup, they are easy for prototyping or finished products. Ess...

The TSL235R light-to-frequency converter outputs a square wave (50% duty cycle) with frequency directly proportional to light intensity (irradi...

Sharp's GP2Y1010AU0F is an optical air quality sensor, designed to sense dust particles. An infrared emitting diode and a phototransistor are di...

The ATtiny45 and 85 are a couple of really cool little MCUs but did you know you can program them in Arduino? That's right, now you can shrink you...

Looking to add MIDI to your project? This is a female, 5-pin, right-angle DIN 5/180° connector which will interface with most standard MIDI cabl...

This is a simple 4 wire cable. Great for jumping from board to board or just about anything else. There is a 4-pin JST RE connector on both ends...

This is a 4" connector cable that interfaces U.FL RF connectors to regular SMA connections. Documents: Datasheet

We have no idea what USB device you are hooking up to, but if you want to access the microUSB port on something, you might want this. We broke out ...

A simple slide potentiometer can go a long way. Rated at 10kOhm and 0.5W. Comes with solder July connections. Documents: Datasheet

Basic breakout board for the TEMT6000 Ambient Light Sensor. Only what you need, nothing you don't. Sensor acts like a transistor - the greater t...

The Line Follower sensor is an add-on for your RedBot that gives your robot the ability to detect lines or nearby objects. The sensor works by det...

This is a perfect choice if you are in need of a heavy duty push button! These metal push buttons are a very tough, small, panel-mount momentary s...

This is a simple 5 wire cable. Great for jumping from board to board or just about anything else. There is a 5-pin JST RE connector on both ends...

Here is a real time clock based on the DS3234 Real Time Clock IC. The DS3234 is a low-cost, extremely accurate SPI bus real-time clock with an int...

Behold, the Hydra! This USB power cable probably looks a lot like something you've hacked together before. We do it all the time, because what is a...

We know this looks like a lot of our other LEDs, but it's not! This is a PTH Addressable RGB LED with a WS2812 control IC built right into the LED...

Are you trying to make a quick dime from electronics? Why limit yourself to dimes? This coin acceptor will take three different kinds of coin! Whet...