MAGENTO IMPORT

Sharp's GP2Y1010AU0F is an optical air quality sensor, designed to sense dust particles. An infrared emitting diode and a phototransistor are di...

The Sabertooth 2X12 is one of the most versatile, efficient and easy to use dual motor drivers on the market. It is suitable for medium powered ro...

CPT-C5 is a power converter module output 5V. Low heat, adopt synchronous rectification technology (5A long-term without any additional cooling me...

The ATtiny45 and 85 are a couple of really cool little MCUs but did you know you can program them in Arduino? That's right, now you can shrink you...

Looking to add MIDI to your project? This is a female, 5-pin, right-angle DIN 5/180° connector which will interface with most standard MIDI cabl...

This is a simple 4 wire cable. Great for jumping from board to board or just about anything else. There is a 4-pin JST RE connector on both ends...

This is a 4" connector cable that interfaces U.FL RF connectors to regular SMA connections. Documents: Datasheet

This hybrid bipolar stepping motor has a 1.8° step angle (200 steps/revolution). Each phase draws 1000 mA at 2.7 V, allowing for a holding torqu...

You want to make a cool Arduino robot, maybe a hexapod walker, or maybe just a piece of art with a lot of moving parts. Or maybe you want to drive...

We have no idea what USB device you are hooking up to, but if you want to access the microUSB port on something, you might want this. We broke out ...

The Relay Shield utilizes four high quality relays and provides NO/NC interfaces that control the load of high current. Which means it could be a ...

MOD-WIFI-ESP8266-DEV is the ultimate development board for ESP8266 with all GPIOs and resources exposed, can be soldered to PCB or used with breadb...

A simple slide potentiometer can go a long way. Rated at 10kOhm and 0.5W. Comes with solder July connections. Documents: Datasheet

This two-part aluminum assembly mounts directly to 6 mm diameter motor output shafts like those on our 37D mm gearmotors and allows you to drive mo...

Set of 5 nylon horns suitable for R/C standard servos.

This lovely little display breakout is the best way to add a small, colorful and bright display to any project. Since the display uses 4-wire SPI t...

Basic breakout board for the TEMT6000 Ambient Light Sensor. Only what you need, nothing you don't. Sensor acts like a transistor - the greater t...

This is a SMD BLE module used in our BLE Bee and Xadow BLE. It is based on TI cc2541 chip, enables robust network nodes to be built with low total...

This board is a simple carrier of Allegro's ±31 A ACS711 Hall effect-based linear current sensor with overcurrent fault output, which offers a low-...

DIGI Part #: XB24-DMWIT-250 XBee and XBee-PRO DigiMesh 2.4 embedded RF modules provide wireless connectivity to end-point devices using a glob...

The Line Follower sensor is an add-on for your RedBot that gives your robot the ability to detect lines or nearby objects. The sensor works by det...

This is a perfect choice if you are in need of a heavy duty push button! These metal push buttons are a very tough, small, panel-mount momentary s...