MAGENTO IMPORT

This is a high-quality color CMOS camera module. Power the CM-32 module, hook up any display, monitor, or LCD screen with an RCA input and get viv...

This is an extra long communication cable, 1 foot in length, that mates with the EM406 and EM401. Cut and hack this cable to your needs. Ideal if...

Hex. Standoffs M/F 3 MA L=25 mm Pack= 5 pcs

• Card holders for printed circuits • Very compact and width-adjustable electronic board support system so that it can be used with any size of pri...

This gearmotor is a miniature (0.94" x 0.39" x 0.47"), high-quality, low-current motor with 100:1 metal gearbox, similar to Sanyo's popular 12 m...

This is the SparkFun RGB and Gesture Sensor, a small breakout board with a built-in APDS-9960 sensor that offers ambient light and color measuring...

This high-speed bipolar stepper with a rear shaft has a 1.8° step angle and 11 kg cm of torque at low speeds. This NEMA-23 motor generates 12.6 kg...

Timing belts are a fantastic way to transfer rotational motion (from a stepper motor) into linear motion (along a rail) and these GT2 belts are ex...

The LM237 and LM337 are adjustable 3-terminal negative-voltage regulators capable of supplying in excess of –1.5 A over an output voltage range of ...

Alcohol sensor is semiconductor sensor for alcohol detection. It has good sensitivity and fast response to alcohol, suitable for...

This IR Distance Interrupter features a high-sensitivity RFR-359F photoreflector to perform distance detection function. The pho...

These color-changing LEDs take the work out of creating crazy, flashy, blinky... ness. Simply apply power and the LED will cycle through the RGB c...

This is a 35mm round momentary push button similar to the ones you find on arcade games. Simple screw in design. Perfect for mashing. Features: ...

This is a simple two wire cable. One end has a 2-pin 0.1" pitch female connector, the opposite end is stripped and tinned stranded wire. Dimensi...

These quick connect battery connectors mate to our battery packs. Simply connect to your unregulated power input on your electronics.

Looking for the best heat sink for your Raspberry Pi 3? Check out this nice and tall 15x15x15mm Heat Sink! This heat sink is made from high qual...

The EasyDriver is a simple to use stepper motor driver, compatible with anything that can output a digital 0 to 5V pulse (or 0 to 3.3V pulse if yo...

Add an ear to your project with this well-designed electret microphone amplifier with AGC. This fully assembled and tested board comes with a 20-2...

The sensor is designed for indoor air quality testing. The main gas detected is carbon monoxide, alcohol, acetone, thinner, formaldehyde and other...

Is this not the cutest little display for the Raspberry Pi? It features a 2.8" display with 320x240 16-bit color pixels and a capacitive touch ove...

The solar charger is a stackable shield to Arduino compatible platforms, enables adaptive battery power and acts as energy harvester for in-field ...