Motors

This gearmotor is a miniature high-power brushed DC motor with a 51.45:1 metal gearbox. It has a cross section of 10 × 12 mm, and the D-shaped gea...

New digital standard servo @7.4V. Very good performance/price ratio. You can have a digital, precise, reliable servo at the same price as analog...

This coated steel bracket lets you securely mount typical NEMA 23-size stepper motors to your project. The bracket features two slots for various m...

This breakout board for TI's DRV8880 microstepping bipolar stepper motor driver features adjustable current limiting, overcurrent and overtemperatu...

OpenCM9.04 is an open-source controller that runs under 32bit ARM Cortex-M3. The C version uses an exclusive 3PIN connector to control the ROB...

The Tic T500 USB Multi-Interface Stepper Motor Controller makes basic control of a stepper motor easy, with quick configuration over USB using our ...

MuIn dsNav is a versatile board based on Microchip dsPIC33FJ motor controller family . Those DSCs, thanks to their unique features, are capa...

The new HS-7985MG High Torque Digital Servo has the added benefit of our new G2 second generation programmable digital circuit. This circuit has...

This motor is much like the GM2 gear motor but runs at nearly twice the speed. Mechanical Features 143:1 gear reduction ratio 7mm output...

Following the size standard of the GM11(a) series of gear motors, this 30:1 reduction unit is very quick - ideal for zippy robot applications! C...

SIX POLES MAGNET: THREE PULSES FOR MOTOR TURN HALL-EFFECT SWITCHES These Hall-effect switches are highly temperature stable and stress-resistan...

81:1, 454RPM, 20mA (220mA stall) at 6V gives 3.17in*oz torque. Not bad, huh? And only available from Solarbotics! These little gear motors me...

This gearmotor is a miniature (0.94" x 0.39" x 0.47") brushed DC motor with 9.96:1 metal gearbox, similar to Sanyo's popular 12 mm gearmotors. T...

This breakout board makes it easy to use Toshiba's TB9051FTG brushed DC motor driver. It has a wide operating voltage range of 4.5 V to 28 V and ca...

The XL-320 servo from ROBOTIS is so small you might mistake it for an ordinary hobby servo, but you would be missing out! Despite its diminutive s...

This NEMA-23 motor has an integrated Planetary gearbox with a 76 49 / 64 :1 ratio. It comes with the rear shaft exposed, so you can mount an enc...

The new line of D digital servos represents yet another evolutionary step in the world of digital servos, bringing performance, precision and vers...

High performance digital microservo, but with more torque, more speed and new electronics optimized to be powered from 6.0 to 7.4V therefore with ...

The PhidgetStepper Unipolar allows you to control the position, velocity, and acceleration of up to 4 unipolar stepper motors. The 1062 can be us...

Note: This revision of the 1065 comes with a built-in heat sink for the driver chip to prevent it from overheating. The 1065 lets you control th...

Add quadrature encoders to your micro metal gearmotors ( extended back shaft version required) with this kit that uses a magnetic disc and Hall eff...

Premium quality 4 Pin cable. Compatible with Dynamixel RX and DX servos and control devices (USB2Dynamixel, SMPS2, etc). 10pcs set