Pololu Mini Plastic Gearmotor Bracket Pair - Tall

These tall brackets offer an easy and convenient mounting solution for our mini plastic gearmotors . The white plastic bracket securely clasps around the gearmotor, and the mounting tabs capture the nuts for easy installation. These brackets are sold in pairs , and each bracket comes with two M3 screws, two nuts, and a spacer.

Overview

These plastic mounting brackets are specifically designed to work with our mini plastic gearmotors (with or without encoders ). Both the offset and 90-degree configurations of the mini plastic gearmotors are compatible with these brackets. The brackets are sold in pairs, and four M3×12mm screws and M3 nuts are included (two for each bracket). In some orientations, the mini plastic gearmotors have a lip that causes the bracket to be raised off of the mounting surface; for those cases, two 1.25mm-thick spacer plates (one for each bracket) are also included. You can see the spacer being used in the two pictures below.

We also offer a wide version of this bracket that allows for alternate mounting options that might be more appropriate for particular applications.

Note: When using this tall version of the bracket with one of the 90° Output mini plastic gearmotors (ie the setup in the left picture above), only our 60mm-diameter wheels (or smaller) will fit in the space between the output shaft and the mounting tab. The mounting tab will rub or interfere with larger-diameter wheels.

Dimensions

Dimension diagram of Mini Plastic Gearmotor Bracket – Tall. Units are mm over [inches].

This diagram is also available as a downloadable PDF (150k pdf).