Sparkfun

This is the SMD version of [PRT-07948](http://www.sparkfun.com/products/7948), which is the unit we like to use as RTC backup and SRAM backup for ...

This 9V battery holder allows your battery to snap in tight and holds it in place, which is great in situations where you don\'t want the battery ...

These are your standard 9 Volt alkaline batteries from Rayovac. Don\'t even think about trying to recharge these. Use them with Arduinos or with a...

This 2xAA battery holder puts a nice finishing touch on your battery powered project. This holder features a removable, sliding cover, which is se...

This is a simple 4 cell AA battery holder. The 5 inch cable is terminated with a standard 5.5x2.1mm, center positive barrel jack connector. The...

This 2xAA battery holder puts a nice finishing touch on your battery powered project. This holder features a removable, sliding cover, which is se...

PCB mount clip to hold a AA battery. Sold in single units, you\'ll need two. These work great for small, low power applications that need a batter...

This is a through-hole 12mm coin cell battery holder. It\'s the unit we like to use as RTC backup and SRAM backup for GPS units. Holds battery in ...

Basic 20mm coin cell holder. Posts can be inserted into 0.1\" perf board! Holds the common CR2032 type batteries. **Documents:** * [Datasheet...

Simple 4 Cell AA Battery holder with 5" tinned leads, square configuration.

Classic 9V snap connector terminated with 2-pin polarized Molex connector with 0.1\" spacing. The cable is 26AWG and is 5\" in length.