Sparkfun

The WS2812B (or \"NeoPixel\") may look like a common 5050-sized (5x5mm) SMD LED, but there's actually an integrated control circuit embedded insid...

This version of the APA102C (or “DotStar”) is the regular, 5050-sized (5mmx5mm) SMD LED. With an integrated control circuit embedded, the APA102C-5...

Amphenol FCI FFC/FPC Flexible Circuit Connectors are a broad range of innovative connector solutions to terminate FFC/FPC. This 24-Pin FPC connect...

This is a 16mm deluxe thumb joystick and is very similar to the \'analog\' joysticks found inside PlayStation controllers. Directional movements ar...

The AS358P is a great, easy-to-use dual-channel Op-amp. Op-amps have so many [applications](http://en.wikipedia.org/wiki/Operational_amplifier_app...

The W25Q32FV (32M-bit) Serial Flash memory provides a storage solution for systems with limited space, pins, and power. This small SMD IC series o...

If you want to get some sound out of your project but have a tight space budget, this is a good way to do it. This 0.5W, 8Ohm speaker is only 40mm...

Keypads are very handy input devices, but who wants to tie up seven GPIO pins, wire up a handful of pull-up resistors, and write firmware that wast...

The SparkFun Buck-Boost Converter is a handy power accessory board that allows you to fine tune the amount of power your project receives. This con...

Gone are the days that you have to worry about silicone weather proofing splitting and breaking on you! These are sealed addressable 1 meter long ...

So much power and light from such a small package. This 3W per channel, Triple Output High Power RGB LED is sure to shed a lot of light on any pro...

Now, you can easily add an HID/controller to your project! The SparkFun Qwiic Joystick combines the convenience of the Qwiic connection system and...

USB-C is quickly becoming more and more prominent in the maker community because, let's be honest, who likes trying three times to insert USB into...

This diode-transistor photocouplers consist of an LED, optically coupled to a high speed photodetector to transmit electrical signals between circ...

Add another eight pins to your microcontroller using a MCP23008 port expander. The MCP23008 uses two I2C pins which can be shared with other I2C de...

Have you ever wanted to control something powerful or have you ever needed to turn on/off a high power device from your Arduino or another low pow...

This is a class 10, 16GB, micro SDHC card that has been pre-installed with the NOOBS (version 3.2.0) operating system for the Raspberry Pi produced...

This is a class 10 16GB microSD memory card, perfect for housing operating systems for single board computers and a multitude of other information...

This is the 8x8 SparkFun LuMini LED Matrix, packed with 64 individually addressable LEDs, each capable of producing 16 million colors, it provides...

The Bourns Absolute Encoder is a digital control knob that provides 128 unique results evenly spaced around a full circle. It is designed as a cont...

This little round on/off/on toggle switch is rated up to 10A at 125VAC and can be panel mounted in a 20mm diameter hole. It'll also look pretty sl...

You don't have to worry about adding a resistor to an LED if you get an LED with a built in resistor! This pack contains 20x 5mm LEDs in four diffe...

This is the one inch version of the SparkFun LuMini LED Ring, packed with 20 individually addressable LEDs, each capable of producing 16 million co...

This is the two inch version of the SparkFun LuMini LED Ring, packed with 40 individually addressable LEDs, each capable of producing 16 million c...