Skip to content
Fermion: MEMS Hydrogen H2 Gas Detection Sensor (Breakout, 0.1-1000ppm)
SKU SEN0572/B

Fermion: MEMS Hydrogen H2 Gas Detection Sensor (Breakout, 0.1-1000ppm)

by DFRobot
€20,35 - €20,35
€20,35
€20,35 - €20,35
€20,35

All prices are VAT included

Availability:
in stock, ready to be shipped
Availability:
Out of stock
Availability:
On order
Shipping: 4-6 Days
Request Quantity Discount and Information

Fermion: MEMS H2 sensor employs state-of-the-art micro-electromechanical system (MEMS) technology, endowing the sensor with compact dimensions (13x13x2.5mm), low power consumption (＜20mA), minimal heat generation, short preheating time, and swift response recovery. The sensor can measure the concentration of hydrogen gas qualitatively. It is suitable for the hydrogen leakage alarm and other application scenarios.

The MEMS series currently encompasses 11 different types of gas sensors ( HCHO , CO , CH4 , VOC , NH3 , H2S , EtOH , Smoke , Odor , H2 , NO2 ), which can be combined as per specific requirements.

Please note: This sensor is capable of only qualitative measurements. For quantitative measurements, kindly consider purchasing the Gravity: Factory Calibrated Electrochemical Gas Sensor Series.

Wiring Diagram of Fermion: MEMS H2 Sensor and Arduino UNO

Figure: Wiring Diagram of Fermion: MEMS H2 Sensor and Arduino UNO


Precautions for use

  • Kindly remove the protective film before use.
  • To prevent exposure to volatile silicon compounds vapors (such as silicone adhesive, hair gel, silicone rubber, or other locations where volatile silicon compounds are present).
  • Avoid exposure to high concentrations of corrosive gases (such as H2S, SOX, Cl2, HCl, etc.).
  • Prevent contamination from alkalis, alkali metal salts, and halogens.
  • Refrain from prolonged exposure to extreme environments (such as high temperatures, high humidity, high pollution).
  • Avoid contact with water, condensation, and freezing.
  • Minimize excessive vibration, impact, and dropping.
  • Please refrain from employing this module in systems that involve personal safety concerns.
  • For extended periods of non-use, it is advisable to preheat the module for at least 24 hours.